Table of Contents
Advertisement
Connecting the
Reader/Writer to a
Computer
Simply connect the reader/writer to a
computer using the supplied USB cable.
1
Start the computer.
2
Connect the smaller connector
of the USB cable to the USB port
on the rear of the reader/writer.
3
Connect the larger connector of
the USB cable to the USB port on
the computer.
The computer recognizes the reader/
writer as a removable disk, and the
reader/writer is ready for use.
Notes
• Do not connect to the USB port on the computer
via an external USB hub.
• Depending on the computer and the status of its
operating system, the reader/writer may not
operate or may become unstable. If this occurs,
refer to the "Troubleshooting" section. (Page 17)
• After disconnecting the USB cable, wait at least
5 seconds before reconnecting it. (Otherwise, the
reader/writer may not be recognized.)
• When two or more USB devices are connected to
one computer, the reader/writer is not guaranteed
to operate simultaneously with some types of
USB device.
• You cannot access two or more memory cards
simultaneously on a single computer by
connecting additional memory card devices.
Remove any memory cards from the reader/
writer or turn off the other devices.
Notes for Windows
• On some computers, a message may appear
asking you to insert the operating system disc.
When this happens, follow the computer's
instructions.
• On some computers, the USB Mass Storage will
function at reduced speed message may appear,
indicating that a hi-speed USB device has been
connected to a USB port which does not support
hi-speed USB. If your computer has multiple
USB ports, try connecting to a different port.
Otherwise, close the message and continue using
the reader/writer with the current port.
7
Advertisement
Table of Contents
