Cleaning The Outboard Motor; Checking Painted Surface Of Motor; Periodic Maintenance - Yamaha LF115 Owner's Manual

Maintenance
TICE: Do not leave the garden hose
connector loose on the bottom cowl-
ing fitting or let the hose hang free
during normal operation. Water will
leak out of the connector instead of
cooling the engine, which can cause
serious overheating. Be sure the con-
nector is tightened securely on the
fitting after flushing the engine.
[ECM00541]
TIP:
When flushing the engine with the boat in
●
the water, tilting up the outboard motor un-
til it is completely out of the water will
achieve better results.
For cooling system flushing instructions,
●
see page 69.
EMU28450

Cleaning the outboard motor

After use, wash the exterior of the outboard
motor with fresh water. Flush the cooling
system with fresh water.
TIP:
For cooling system flushing instructions, see
page 69.
EMU28460

Checking painted surface of motor

Check the motor for scratches, nicks, or flak-
ing paint. Areas with damaged paint are
more likely to corrode. If necessary, clean
and paint the areas. A touch-up paint is avail-
72
able from your Yamaha dealer.
EMU2848A
EWM01871
WARNING
These procedures require mechanical
skills, tools, and supplies. If you do not
have the proper skills, tools, or supplies
to perform a maintenance procedure,
have a Yamaha dealer or other qualified
mechanic do the work.
The procedures involve disassembling
the motor and exposing dangerous parts.
To reduce the risk of injury from moving,
hot, or electrical parts:
Turn off the engine and keep the key(s)
●
and engine shut-off cord (lanyard) with
you when you perform maintenance
unless otherwise specified.
The power trim and tilt switches oper-
●
ate even when the ignition key is off.
Keep people away from the switches
whenever working around the motor.
When the motor is tilted, keep away
from the area under it or between it and
the clamp bracket. Be sure no one is in
this area before operating the power
trim and tilt mechanism.
Allow the engine to cool before han-
●
dling hot parts or fluids.
Always completely reassemble the mo-
●
ZMU04265
tor before operation.
Maintenance, replacement, or repair of
the emission control devices and sys-
tems may be performed by any marine
engine repair establishment or individual.
All warranty repairs, however, including
those to the emission control system,
must be performed by an authorized
Yamaha marine dealership.
A service manual is available for purchase

Periodic maintenance