Preparation; Unpacking The Tv - JVC LT-32C650A Instruction Manual

32" led smart hd tv

Hide thumbs Also See for LT-32C650A:

Quick start manual (2 pages)

Quick start manual

Table Of Contents

Table of Contents

Chapter

Preparation

Thank you

Your new TV has many features and incorporates the latest technology to enhance your viewing

experience. We recommend that you spend some time reading this instruction manual so that you fully

understand these features. You will also find some hints and tips to help you resolve any issues.

Read all the safety instructions carefully before use and keep this instruction manual for future reference.

Unpacking the TV

Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.

The following items are included:

TV Stand

Instruction Manual

32" LED Smart HD TV

LT-32C650(A)

Instruction Manual

for purchasing your new JVC TV.

Quick Start Guide

32" LED Smart HD TV

LT-32C650(A)

Thank you

for purchasing your new JVC TV.

Your new TV incorporates the latest technology to enhance your viewing

experience. We would suggest that you allow about 20 mins for initial setup.

Please follow this guide for a successful first time installation.

The latest eco-friendly power-saving technology will switch off the TV if

it is left on and idle for 4 hours. Please refer to "Auto Standby" under the

"Time Settings" section of the instruction manual for more detail.

Unpacking

Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.

R emote Control/

AAA Batteries x2

TV Stand

Screws x 4

Please inspect your TV for damage after unpacking. If you do notice any damage please consult your dealer.

Operating Your Remote Control

1. Slide open the battery compartment on the back of the remote control.

2. Insert two AAA size batteries. Make sure to match the (+) and ( - )

ends of the batteries with the (+) and ( - ) ends indicated in the battery

compartment.

3. Slide the battery compartment cover back into place. Make sure it clicks

into place.

LT-32C650(A)_QSG.indd 1

Quick Start Guide

Stand screws x4

Installing the Base Stand

Fitting the Stand to the TV

1. Ensure the TV is switched off and not connected to the mains power supply.

2. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly overhangs the edge of the table, with the back

side facing up. Please make sure a soft cushioned material (such as a dry bath towel or thick piece of foam) is placed beneath the screen.

3. Slide the stand under the lip, the neck will fit snugly over the screw holes. Then screw the stand to the TV using the 4 screws supplied.

LAN

SPDIF

VGA

Optic.OUT

SCART

Slide under

the lip

Cushioned

Table

material

The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object,

or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because

the screen could crack.

FAV Cable

Connecting the Aerial and Turning on the TV

Instruction Manual

Quick Start Guide

1. Connect one end of the RF coaxial cable to the aerial socket on the wall

and the other end of the cable to the ANT socket on the back of your TV.

Optional

2. Plug the TV into a mains socket and switch on at the mains.

If you want to connect to the internet via a wired connection

then connect your ethernet cable to the LAN socket.

3. In standby mode, press the button on the remote control to turn the