Advanced; Network Management - Bosch DINION inteox 7100i IR User Manual

40 en | Configuration
Network MSS [Byte]
Set the maximum segment size for the IP packet's user data here. This gives the option to
adjust the size of the data packets to the network environment and to optimize data
transmission. In UDP mode, comply with the MTU value set below.
Network MTU [Byte]
Specify a maximum value in bytes for the package size (including IP header) to optimize data
transmission.
Click Set to apply the changes.
4.8.3

Advanced

RTSP
RTSP port
If necessary, select a different port for the exchange of the RTSP data from the list. The
standard RTSP port is 554. Select Off to deactivate the RTSP function.
802.1x
Authentication
To configure Radius server authentication, connect the unit directly to a computer using a
network cable. If a Radius server controls access rights over the network, select On to activate
authentication to communicate with the unit.
Identity
Enter the user name that the Radius server uses for the unit in the Identity field.
Password [EAP-MD5]
Enter the Password [EAP-MD5] that the Radius server expects from the unit.
Certificates [EAP-TLS]
Shows the client and server certificates.
Click Configure to go to the Certificates page and manage certificates.
Syslog
Server IP address
Enter the appropriate IP address of the server.
Server port (0 = Off)
Enter the number of the server port.
Protocol
Select the appropriate protocol: UDP, TCP, or TLS.
Click Set to apply the changes.
4.8.4

Network Management

Quality of service
The camera offers Quality of Service (QoS) configuration options to ensure fast network
response to PTZ data and images. Quality of Service (QoS) is the set of techniques to manage
network resources. QoS manages the delay, delay variation (jitter), bandwidth, and packet
loss parameters to guarantee the ability of a network to deliver predictable results. QoS
identifies the type of data in a data packet and divides the packets into traffic classes that can
be prioritized for forwarding.
Consult with your network administrator for assistance configuring the Audio, Video, Control,
and the Alarm video settings, and to select the appropriate Post-alarm time.
Post-alarm time has a time period from 0 s [seconds] to 3 h [hours]; 15 s [seconds] is the
default option.
2021-08 | V01 | DOC
DINION inteox 7100i IR | FLEXIDOME inteox 7100i
User manual
Bosch Security Systems B.V.