Table of Contents
Advertisement
20.2 Fitting the retainers
The retainers may fall out when you detach the rails.
Note:
The retainers at the front differ from those at the rear.
Hook the front retainers with the hook into the round
1.
hole at the top and set them at a slight angle
Hook the front retainers in at the bottom and
2.
straighten them
.
21 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
21.1 Removing the door cover
The stainless steel inlay in the door cover may discol-
our. Remove the door cover in order to clean it and the
stainless steel inlay, or to remove the door panes.
Open the appliance door slightly.
1.
Press down on the left- and right-hand sides of the
2.
door cover.
Hook the rear retainers with the hook into the top
3.
hole
and push them into the bottom hole
20.3 Attaching the rails
Notes
¡ When hanging the rails, ensure that the sloping
edge is at the top of the rail.
.
¡ The rails fit both the left- and right-hand sides.
Set the rear rail at an angle, hooking it into the re-
1.
tainers at the top and bottom
Pull the rail forwards
2.
Hook in the rail at the front
3.
Remove the door cover and carefully close the ap-
3.
pliance door.
Appliance door en
.
.
.
and press it down
.
25
Advertisement
Table of Contents
