Precautions When Using Discs; Precautions When Using Audio Cassettes; Before Contacting The After-Sales Service - Samsung MAX-KDZ100 Instruction Manual

Precautions When Using Discs

GB
Handle your discs with care. Always hold them by the edges to
avoid leaving fingerprints on the shiny surface.
When you have finished playing a disc, always put it back in its
case.
Do not fix paper or adhesive tape to the discs and do not write on
the label.
Clean them with a special-purpose cloth.
Store your discs in a clean place, out of direct sunlight, where they
will not be exposed to high temperatures.
Precautions When Using Audio
Cassettes
Check that the tape in the cassette is sufficiently taught.
To prevent erasing a cassette that you wish to keep, remove the
safety tab on the upper edge of the cassette. To record a cassette,
where the tab has been broken, simply cover the opening with
adhesive tape.
When you have finished playing a cassette, always put it back in its
case.
Store your cassettes in a clean place, out of direct sunlight, where
they will not be exposed to high temperatures.
Avoid using 120-minute cassettes as they place unnecessary strain
on the tape mechanism.
33
Before Contacting the After-Sales
Service
Refer to the chart below when this unit does not function properly. If the
problem you are experiencing is not listed below or if the instruction below
does not help, turn off the unit, disconnect the power cord, and contact the
nearest authorized dealer or Samsung Electronics Service Center.
Problem
The system does not work
G
There is no sound
E
N
E
R
A
L
The Timer does not work
In case it does not work, even the
action is taken as above.
The disc player does not start
playing
D
V
D
/
C
D When playing a DTS, DVD disc,
no sound is produced.
The tape does not start playing
C
A
S
S
E
T
The volume falls off
T
E The cassette is not erased correctly
S
There is excessive wow and flutter
Reception is poor or no radio sta-
tions are received at all
R
A
D
I
O
Checks/Explanation
• The main lead is not correctly plugged into a
wall socket or the wall socket is not switched
on.
• The remote control batteries need replacing
or the polarity has not been respected.
• The Standby/On button has not been
pressed.
• The volume has been completely turned
down.
• The correct function (TUNER, DVD/CD,
TAPE, AUX) has not been selected.
• You have connected a set of earphones.
• The loudspeaker wires have been
disconnected.
• The MUTE button has been pressed.
• The timer has been stopped by pressing
Timer On/Off.
• Press the P. Surround button for 5 seconds in
power 'OFF'(standby), then it is returned the
original position (RESET)
• The DVD/CD function has not been selected.
• The disc has been inserted face down or is
either dirty or scratched.
• The laser sensor is dirty or dusty.
• The system has not been installed on a flat,
horizontal surface.
• Condensation has formed in the player; leave
the system in a warm, airy room for at least
one hour.
• Since this product incorporates technology,
no sound will be output directly from the main
unit.
• To listen to DTS sound, connect an amplifier
equipped with a DTS decoder to the digital
output (OPTICAL OUT).
• The TAPE function has not been selected.
• The cassette has not been inserted correctly.
• The cassette player has not been closed.
• The tape is either slack or broken.
• The audio heads are dirty.
• The rollers or drive capstans are dirty.
• The tape is worn.
• The TUNER function has not been selected.
• The radio frequency has not been correctly
selected.
• The aerial has been disconnected or is not
facing the right way. Turn it until you find the
best orientation.
• You are in a building that blocks radio waves;
you must use an outside aerial.