Table of Contents
Advertisement
7. Use the clamp from the piston assembly kit to
compress the piston ring. Carefully push the piston
into the cylinder opening. Tighten the 2 screws to
the specified torque. Refer to
6 .
8. Install the remaining parts in the opposite sequence
to how they were removed.
7.13 Crankshaft and crankcase
7.13.1 To get access to the crankcase and
crankshaft
To remove the cylinder and piston
1. Do step 1-13 in
on page 39 .
2. Remove the ignition module, if it is attached.
44 - Repair instructions
Servicing data on page
7.13.2 To disassemble the crankcase and
crankshaft
1. Remove the 3 screws and disconnect the crankcase
halves.
2. Lift the crankshaft out of the crankcase half on the
starter side.
Note: The crankshaft has a tight fit in the crankshaft
bearing.
3. Remove the gasket and clean remaining gasket
material from the surfaces.
1017 - 002 - 25.11.2020
Advertisement
Table of Contents
