Related Manuals for Samsung VS20C95 Series
Summary of Contents for Samsung VS20C95 Series
- Page 1 Vacuum cleaner User manual VS20C95**** Series • Before operating this unit, please read the instructions carefully. • For indoor use only...
-
Page 2: Table Of Contents
Contents Safety information Operation Important safety symbols Installing the charging stand General Using the charging stand Vacuum cleaner Charging the battery Maintenance Inserting the battery Charging stand Ejecting the battery Battery Charging the additional battery Using the buttons and display Using the accessories Preparation Accessories... -
Page 3: Safety Information
Safety information • Before operating the appliance, please read this manual thoroughly and retain it for your reference. • Because the following operating instructions cover various models, the characteristics of your vacuum cleaner may differ slightly from those described in this manual. Important safety symbols WARNING Indicates that a danger of death or serious injury exists. -
Page 4: General
Safety information General For information on Samsung’s environmental commitments and product specific regulatory obligations e.g. REACH (WEEE, Batteries) visit: samsung.com/uk/aboutsamsung/samsungelectronics/ corporatecitizenship/data_corner.html Failure to meet these requirements could cause damage to the internal parts of the vacuum and void your warranty. - Page 5 – An explosion or fire may occur. • If the product makes a strange sound or emits a smell or smoke, turn off the product immediately, and then contact a Samsung service center. – Electric shock or fire may occur.
- Page 6 – If there is foreign matter on the wheel of the brush which cannot be removed easily, contact a Samsung service center. • When the spin brush inside a brush is working, do not touch the brush.
-
Page 7: Maintenance
– If water gets into the product and an error occurs, turn off the product and contact a Samsung service center. • When cleaning the washable parts, do not use alkaline detergent, acid, industrial detergent, air freshener, acetic acid, etc. -
Page 8: Charging Stand
Safety information Dustbin, Washable Micro Filter, Fine Dust Filter, Metal Mesh Washable Parts Grille Filter, dry cloth Acceptable Neutral Dish washing detergent detergent Alkaline Lox, mold cleaner, etc. Acid Paraffin oil, an emulsifier, etc. Industrial NV-I, PB-I, Opti, alcohol, acetone, benzene, thinner, etc. Prohibited cleaners detergent... - Page 9 – Product malfunction or electric shock may occur. • As the charging stand is designed for the use of Samsung Jet cordless vacuum cleaner only, do not use the charging stand for other electronic appliances and other purposes.
-
Page 10: Battery
• When you purchase a new battery, make sure to check the model name (VCA-SBTA95) and the genuine logo. – Contact your nearest Samsung Electronics retailer or Samsung service center to purchase any consumable accessories. English... - Page 11 • Leaks from battery cells can occur under extreme usage or temperature conditions. If the liquid gets on your skin, wash the affected area quickly with water. If the liquid gets into your eyes, flush them immediately with clean water for a minimum of 10 minutes. Seek medical attention.
-
Page 12: Preparation
Preparation Accessories The accessories with the ' * ' mark may differ depending on the models. Telescopic pipe Pet Tool+ Combination Tool Extension Crevice Tool Flexible Tool User manual * Jet Dual Brush * Slim LED Brush Charging stand * Disposable wet pads / * Spray Spinning Sweeper / Attachable pad Water tank / Reusable wet pads... -
Page 13: Parts Overview
Parts overview 10 Handle 01 Power ( ) button 11 Battery level indicator 02 Suction power control buttons 12 Battery release button 03 Washable Micro Filter 13 Pipe release button 04 Metal Mesh Grille Filter 14 Pipe length adjustment button 05 Display 15 Brush release button 06 Dustbin release button... -
Page 14: Operation
Operation Installing the charging stand 1. Place the stand pipe on the bottom support, and screw the pieces together using the included small screw. Make sure the pieces are aligned correctly and push it in firmly so that the screw hole is aligned. -
Page 15: Using The Charging Stand
Using the charging stand Charging • Make sure the back of the battery is correctly placed onto the vacuum charging part. • Check if the battery level indicator is displayed while charging. • The battery level indicator blinks while charging. When charging is complete, the blinking stops and the light level dims. -
Page 16: Charging The Battery
Operation Storing the accessories • When accessories are disassembled to be stored, dust may fall from the suction part of the vacuum cleaner. • After cleaning, shorten the pipe length and operate in MAX mode for 10 seconds. Storing the Spray Spinning Sweeper When the brush holder is connected to the charging stand, the Spray Spinning Sweeper can also be stored at the charging stand. -
Page 17: Inserting The Battery
Inserting the battery Push the battery to the end until you hear it click. Ejecting the battery Press the battery release button at the rear of the handle to eject the battery. CAUTION • Before ejecting the battery, the vacuum cleaner must be turned off. -
Page 18: Using The Buttons And Display
Operation Using the buttons and display 01 Display Displays the current mode (‘MIN, MID, MAX, JET, or WET’) or the alert message. 02 Power ( Press this button to turn on or off the vacuum cleaner. When you turn on the power, the vacuum cleaner starts in the ‘MID’ mode. -
Page 19: Using The Accessories
Using the accessories Detaching the accessories • To detach the accessories, press the release button on the back of each accessory. • Before detaching the accessories, operate the vacuum cleaner in the 'MAX' mode for 10 seconds to prevent any foreign matter remains inside the accessory. - Page 20 Operation Spray Spinning Sweeper Use to clean a wood and linoleum floor with a wet Reusable wet pad pad. • The Spray Spinning Sweeper does not have a Spin disk dust suction function. Using the reusable wet pad • When attaching the wet pad, make sure the pad is in the center of the spin disk.
-
Page 21: Maintenance
Maintenance Cleaning the vacuum cleaner Dustbin/Washable Micro Filter CAUTION • After cleaning the dustbin and Washable Micro Filter with water, you should dry them completely in the shade for more than 24 hours before use. When heat is applied, part deformation may occur. If the filter is not dried completely before being used, it can cause an odor. - Page 22 Maintenance Fine Dust Filter Make sure to turn off the product before cleaning the filter. • Twist and pull off the Fine Dust Filter, and tap it gently to remove the dust. • Wash the filter with running water once a month to maintain the best performance of the filter. •...
- Page 23 Slim LED Brush ‘Click’ CAUTION • Do not clean the brush with water. • When foreign matter remains on the brush, remove it with a wet tissue or a dry cloth. NOTE • If the spin brush does not work after cleaning the Slim LED Brush, the overheating prevention device of the motor may have been enabled.
- Page 24 Maintenance Slim LED Brush roller wheels Use a small screwdriver to disassemble the front and rear roller wheels. NOTE Rear roller wheel Tools required for disassembly. Flat head screwdriver (3 mm or less in width), Phillips Front roller screwdriver, prying tool. wheel CAUTION •...
- Page 25 Rear roller wheel Release lever ‘Click’ Release lever • Lift the release lever to detach the rear roller wheel. • Detach the rear roller wheel and remove the tangled foreign matter. Then, reassemble the wheel. • Insert the rear roller wheel into its place, and then press the release lever until you hear a click. CAUTION Be careful not to damage the release lever with a screwdriver.
- Page 26 Maintenance Spray Spinning Sweeper NOTE If the spin disk does not work after cleaning the Spray Spinning Sweeper, the overheating prevention device of the motor may have been enabled. Wait 30 minutes or more to cool the motor and operate again. Pet Tool+ Cut the tangled hair or fur with scissors, and then use a vacuum cleaner to suck up the pieces.
-
Page 27: Appendix
• Install the charging stand in a place where there are no objects that could break and cause damage. • If you have a problem with installing the charging stand, contact a Samsung service center. English 27... - Page 28 • If the product does not work after you charge the battery, replace the battery. If it still does not work with the new battery, contact a Samsung service center. CAUTION • Do not disassemble the battery or the charging stand.
- Page 29 Do not boil the wet pad. • Use a genuine wet pad of Samsung Electronics for the Spray Spinning Sweeper. • If the Spray Spinning Sweeper is used without a wet pad, any product malfunction will not be covered by warranty and a service fee will be charged.
- Page 30 Appendix CAUTION • Do not leave the product leaning against a wall or a table. – The product may fall and an injury and severe product damage may occur. • Do not allow children to touch the product while cleaning. –...
- Page 31 Maintenance NOTE • If the inner part of the Spray Spinning Sweeper is clogged with large foreign matter, spinning speed decreases or the spin disk stops. CAUTION • Do not push the vacuum cleaner while it is stored in the charging stand.
-
Page 32: Troubleshooting
• Replacement filters are available at your local Samsung service agent. • Materials of a mat (childcare center mat, noise prevention mat for Static electricity occurs between floors, etc.) may cause the static electricity. - Page 33 Problem Solutions • As this product has the overheating prevention device of the motor, product will stop operation temporarily for the following conditions. After correcting the cause of the problem, turn the product on again. (This case Vacuum cleaner stops may differ depending on the ambient temperature.) operation during cleaning.
-
Page 34: Product Specification
Appendix Product specification Charging and cleaning time may differ depending on the brushes and the conditions of use. Model VS20C95**** Series Power consumption (Vacuum cleaner) Based on a handy vacuum cleaner: 580 W Battery specification Li-ion 25.2 V, 2200 mAh, 7 cell 2.71 kg (Jet Dual Brush) Weight (Vacuum cleaner) 2.51 kg (Slim LED Brush) - Page 35 Memo...
- Page 36 DJ68-00901C-00...