AEG HK634060XB User Manual page 14

14 www.aeg.com
Problem
Automatic Heat Up does not
operate.
You cannot activate the out-
er ring.
There is a dark area on
the multiple zone.
The sensor fields become
hot.
comes on.
and a number come on.
You can hear a constant
beep noise.
comes on.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
Possible cause
The zone is hot.
The highest heat setting is
set.
You decreased the heat set-
ting to 0.
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large or
you put it too near to the
controls.
Child Safety Device or Lock
operates.
There is an error in the hob.
The electrical connection is
incorrect.
The second phase of the
power supply is missing.
three digit letter code for the glass
ceramic (it is in the corner of the glass
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
Remedy
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the func-
tion.
Start from 0 and increase the
heat setting.
First, activate the inner ring
by changing the heat set-
ting.
Put large cookware on the
rear zones, if possible.
Refer to "Daily use".
Deactivate the hob and acti-
vate it again after 30 sec-
onds. If comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin-
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a quali-
fied electrician to check the
installation.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse,
wait one minute, and insert
the fuse again.