Before You Begin
Observe the following precautions to help prevent shutdowns, equipment failures, and
personal injury:
•
Install the DIS-F200G in a cool and dry place. Refer to the technical specifications in the
user manual for the acceptable operating temperature and humidity ranges.
•
Leave at least 10 cm of space at the top, rear and bottom of the Switch for ventilation.
•
Visually inspect the power connector and make sure that it is fully secured to the
power cord.
•
Do not stack any devices on top of the Switch.
It is also recommended that power and grounding requirements are investigated before
mounting the Switch.
Mounting the Switch on a DIN Rail
Before beginning either mounting or removing the DIS-F200G from a DIN rail, please
ensure that the DIN rail is level and that the DIN rail mounting kit is installed correctly on
the DIS-F200G. Use the following instructions to install the DIS-F200G on a DIN rail:
1.
With the back of the DIS-F200G facing the DIN rail, lower the top part of the rail
mounting kit onto the DIN rail.
2.
Push the DIS-F200G vertically down and rotate the bottom of the DIS-F200G towards
the DIN rail, to attach the Switch to the DIN rail.
Use the following instructions to remove the DIS-F200G from a DIN rail:
1.
Push the DIS-F200G vertically down to create enough space at the bottom of the rail
mounting kit to remove the DIS-F200G from the DIN rail.
2.
Rotate the DIS-F200G upwards to remove the bottom of the rail mounting kit from the
rail, and lift the DIS-F200G upwards to remove the whole of the Switch from the DIN rail.
Grounding the Switch
To use the DIS-F200G safely, it needs to be grounded. Insert a grounding wire into the termi-
nal grounding connection and use a flat head screwdriver to tighten the screw to secure the
wire. Attach the other end of the grounding cable to an appropriate grounding source.
Grounding Wire
QUICK INSTALLATION GUIDE | DIS-F200G SERIES
HARDWARE INSTALLATION
4