Setting The Signal; Sensors; Automatic Load Sensing; Unbalanced Load Detection System - Bosch WAP28481AU Instruction Manual

M

Setting the signal

Y ou can change the following settings:
S e t t i n g t h e s i g n a l
The volume for the information
■
signals (e.g. at the end of the
program) and/or
The volume of the audible button
■
signals.
You will need to activate the setting
mode in order to change these settings.
1/2/3/... positions on the program
selector
Activate setting mode:
Set the program selector to
1.
position 1. The washing machine is
switched on.
Press the A button and, at the
2.
same time, turn the program selector
clockwise to position 2.Release the
button.
The setting mode is activated and the
preset volume for the information
signals appears in the display panel
(e.g. at the end of the program).
Changing the volume
Use the (ñ Ready in//ñ Finished in)
button to change the following settings
at the corresponding program selector
positions:
2: The volume of the information
■
signals and/or
3: The volume of the button signals.
■
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
Setting the signal
Exiting setting mode
You can now end the process and set
the program selector to the Off position.
The settings are saved.
H

Sensors

A utomatic load sensing
S e n s o r s
The automatic load-sensing function
perfectly adapts the water consumption
to each programme depending on the
type of fabric and the load.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping the drum spinning.
If the laundry is extremely unevenly
distributed, the spin speed is reduced
or the spin cycle is not performed for
safety reasons.
Place large and small items of
Note:
laundry evenly in the drum.
~ "Faults and what to do about them"
on page 25
en
21