Black & Decker 17182418 - Spreader Manual

INSTALLING THE BATTERIES

Ensure on/off switch (See figure 1) is in the full "OFF" position.

BEFORE OPERATING THE FIRST TIME REALESE THE SAFTY SCREW AND REMOVE BATTERY SHIPPING STRIP. (See figure 2)

To replace batteries, insert 4 fresh 1.5 volt AA alkaline batteries making sure to match (+) and (-) terminals correctly.
Replace the battery compartment cover and securely rotate into place.
(See figures 8 and 9)


BATTERIES CAN EXPLODE, OR LEAK, AND CAN CAUSE INJURY OR FIRE.
To reduce this risk:

• Do not open or mutilate the batteries. Released electrolyte is corrosiveand may cause damage to the eyes or skin. It may be toxic if swallowed.
• Carefully follow all instructions and warnings on the battery labeland package.
• Always insert battery correctly with regard to polarity (+ and -), markedon the battery and the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• Remove dead battery immediately and dispose of per local codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries if the device will not be used for several months.
• Use only AA Alkaline batteries
• Not for use with rechargeable batteries
• Do not mix old and new batteries. Replace all of them at the same time withnew batteries of the same brand and type.
• Transporting batteries can possibly cause fires if the battery terminalsinadvertently come in contact with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes (i.e. packed in suitcases and carryon luggage) UNLESS they are properly protected from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit.

OPERATING INSTRUCTIONS

1. While filling make sure motor is in the off position - (See figure 1), hold spreader over a paved surface.
   Use the fill line for maximum load (See figure 4)
   
2. Adjust flow rate settings. (See figure 3)
   Your product instructions will indicate lbs. per sq. ft. needed (for light rates such as 1lb to 2lbs per 1,000 sq.ft. reduce flow setting, for higher rates such as 5lbs. to 6lbs per 1,000 sq. ft. increase flow setting).
   
3. Set motor speed to desired flow coverage. Cover a small area to test ratesettings, adjust settings if necessary. (See figures 5A and 5B)
   
4. Slide trigger lock backwards and pull trigger while walking at a normal speedover the area that is being covered. Trigger activates flow door and spreader wheel simultaneously. (See figures 6A and 6B)
   
   For most ergonomically recommended position please see figure 7.
   
5. Media is dispersed over the spread range angle indicated in figure 4.
6. When refilling repeat directions and continue spreading.

Recommended Settings:
(See figure 3)

• Fine Grass Seeds: 1
• Coarse Grass seeds: 2
• Light Fertilizer: 3
• Heavy Fertilizer: 4
• Pelletized fertilizer & Ice melt: 5

MAINTENANCE

After use, clean the spreader thoroughly with mild soap and a damp cloth. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid.