AEG AWUD040B8B User Manual page 83

Hide thumbs Also See for AWUD040B8B:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 75
decrease key until you reach the
desired temperature.
By default, the temperature
digits show the current
temperature at half
brightness. When you tap
once or start selecting a new
setting, the displayed digits
blink. After 3 seconds
without tapping the keys, the
digits stop blinking and the
current temperature is
displayed.
To set the right temperature for each
type of wine, refer to the "Daily use"
chapter.
5.5 Light setup
Tap the Light key once to turn the light
on or off. The default light setting is 1A
for the light behaviour and 9L for the light
brightness.
The light has no negative
effect on the quality of wine.
You may adjust behaviour and
brightness of the light.
Light behaviour (A):
• 1A door open - lights on at the highest
dimming level, door closed - lights
turn off
• 2A door open - lights on at the highest
dimming level, door closed - lights on
at the selected dimming level
• 3A door open and closed - lights on at
the selected dimming level
• 4A door open - lights on at the
selected dimming level, door closed -
lights on at the highest dimming level
Light brightness (L):
• 9L is the brightest setting while 1L is
the dimmest one.
To set the light behaviour or brightness:
1. Tap and hold the Light key for 3
seconds to enter the light setting
menu.Top compartment indicator
blinks showing the light behaviour A,
bottom compartment indicator blinks
showing the light brightness L.
2. Tap the temperature regulators of
each compartment repeatedly to
choose the desired setting.
5.6 Cellaring
In this mode, the appliance's
compartments switch to the preset
default temperature of 12°C.
To activate the Cellaring mode, tap
repeatedly the Cellar Mode key. CE
appears and blinks in sequence for top,
bottom and both compartments. Wait 5
seconds. The mode is active when CE
stops blinking and is lit at half brightness.
To deactivate the Cellaring mode, tap
Cellar Mode repeatedly until the
temperature digits appear.
5.7 Child Lock mode
Activate the Child Lock mode to lock the
keys from an unintentional operation.
To activate the Child Lock, tap and hold
the Cellar Mode key for 3 seconds.
When the mode is on, the lock indicator
lights up at full brightness. After 3
seconds, the lock indicator dims to half
brightness.
If you press any key other
than Cellar Mode, the lock
indicator blinks three times.
To deactivate the Child Lock mode, tap
the corresponding key again.
The Child Lock mode
deactivates after electricity
interruption or unplugging
the appliance.
5.8 Reset air filter
To reset the air filter alarm:
1. Change the carbon air filter. Refer to
the "Replacing air filter" section.
2. Tap and hold the Temperature
increase and Light keys
simultaneously for 5 seconds.
3. The filter indicator turns off for the
next 6 months.
After 6 months, the display
shows the filter indicator to
remind you to replace filter.
5.9 Mute or unmute sounds
The sounds are enabled by default.
ENGLISH
83

Advertisement

Table of Contents
loading

Table of Contents