Gluing; Procedure For Visual Checking (Rp Chart) - Panasonic Lumix H-FS14140 Service Training Manual

Hide thumbs Also See for Lumix H-FS14140:

Table of Contents

7.4.7. Gluing

1. After all work completed, glue 2 Adjustment Pins, and assembling the Dust Proof Ring and Filter Ring,

Decoration Ring.

1. Mount repaired Lens on master camera sample. (valid pixels : 16M pixels image sensor)

2. Mount master camera on tripod.

3. Set camera as next.

- Aperture : AE priority by Rear Mode Dial

- Focus : AFS

- ISO : 200

- OIS : OFF

- White Balance : AWB

- AF Mode : 1- Area (Focus subject in AF area)

- Metering Mode : Centre weighted (Focus and measure the subject on the centre of the screen)

- Picture Size : L (16M)

- Picture Quality : Fine (JPEG Give priority to the picture quality)

4. Adjustment distance between the camera and RP-Chart so that picture size and horizontal level in

TELE (RP Chart M-Size) and WIDE (RP Chart L-Size) is full display (camera LCD).

5. Focus on centre in the open aperture state (TELE : 5.6, WIDE : 3.5), take photo by self-timer mode

as camera shake does not occur.

6. As the Shutter Speed of photo taken will be 1/30～1/125, adjust the shooting enviroment. (Brightness)

(The Shutter Speed is confirmed in the Exif information)

7. Shooting photos to display at an equal magnification on the PC screen.

By visual check : None piece out-of-focus of resolution number at horizontal and vertical direction.

The balance of resolution number at horizotal and vertical direction is maintained.

Observation point : Four corners (Angle of view 0.7 and wedge-shaped mark of the outermost)

8. If it has piece out-of-focus, repeat the 1st Lens Frame Adjustment.

(If it has piece out-of-focus more than three times, implement the re-assembly and re-exchange

of replacement parts.)

RP Chart

Table of Contents