Replace The Cover - Cisco C111 8P Series Hardware Installation Manual

Install and Upgrade Internal Modules and Field Replaceable Units
Step 3
Disconnect all port cables connected to the router. Ensure that you do not work on the router with cables still attached to
the router in the event of lightning or surges.
Step 4 Installer to disconnect all cables connected to the system.
Step 5
Place the chassis on a flat surface.
Step 6 Remove the 14x cover screws on the two sides of the router cover. See figure.
Step 7
Slide the cover from bezel side to I/O side until it stops.
Step 8 Pull the cover vertically to disengage from the chassis.

Replace the Cover

To replace the cover, do these steps:
Warning
The covers are an integral part of the safety design of the product. Do not operate the unit without the covers
installed. Statement 1077.
1 and 2 Replace the 14 screws on either side of the cover.
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
Replace the Cover
61