Key To Symbols; Symbols On The Machine And/Or In The Oper Ator's Manual - Husqvarna 455e Rancher Operator's Manual

Symbols on the mac hine and/or in
the operator's manual::
W ARNING! Chain saws can be dangerous!
Careless or improper use can result in
serious or fatal injury to the operator or
others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be used
to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any object
must be avoided.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May cause
serious personal injury.
Recommended cutting
equipment in this example:
- Bar length 20 inches
- Max tooth count for the
bar nose sprocket is 11T
- Chain type Husqvarna H80
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination
on the label.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
Chain brake, activated (right)
Chain brake, not activated (left)
2 – English
KEY T O SYMBOLS
Decompression v alve: Press the valve
to reduce the pressure in the cylinder and
make starting easier. You should always
use the decompression valve when
starting the machine.
Ignition; choke: Set the choke control
in the choke position. This should
automatically set the stop switch to the
start position.
Air purge
Adjustment of the oil pump
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
Switch off the engine b y moving the
stop switch to the STOP position
before carrying out any checks or
maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must
be worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake should be activated
when starting.
1153137-32 Rev .2 2009-12-29