Troubleshooting - Philips BRE64 Series Manual

Facial cap
You can attach the facial cap onto the epilating head for precise epilation of
facial hair (e.g. above your upper lip).
Do not use the appliance to epilate eyelashes, eyebrows or scalp
hair.
Shaving head
You can use the shaving head to shave your legs and body.
Note: The appliance can be moved in two directions, for easier shaving of
underarms.
Note: Always check the foil before use. If it is damaged in any way, replace
the cutting unit right away (see 'Replacement').
Comb for shaving head
You can attach the comb onto the shaving head to trim hairs to a length of
3mm.
Trimming head
You can use the trimming head to trim hard-to-reach areas in the bikini
zone.
Place the trimming head flat onto the skin to trim (Fig. 16). Place the
trimming head perpendicularly onto the skin for styling and shaping (Fig. 17).
Comb for trimming head
You can attach the comb onto the trimming head to trim hairs in the bikini
area to a length of 3mm (Fig. 18).
Body massage head
The body massage head rotates firmly to relax your muscles.
Note: You have to put the body massage head on the coupling unit before
you can attach it onto the handle (Fig. 19).
Body exfoliation brush
You can use the body exfoliation brush to remove dead skin cells.
Do not use the body exfoliation brush on your face.
Note: You have to put the body exfoliation brush on the coupling unit
before you can attach it onto the handle (Fig. 20).
Cleaning and storage
Keep the adapter dry.
1 To clean the epilating head, hold the appliance upside down, switch it
on and rinse it with cold water for 15 seconds after every use (Fig. 21).
2 To clean the shaving head (if supplied): Use the cleaning brush to brush
away any hairs that have collected under the trimmers. Grab the two
trimmers of the cutting unit and pull the cutting unit out of the shaving
head (Fig. 22). Clean all parts of the shaving head with the cleaning
brush, except the foil.
Note: Lubricate trimmer teeth and foils with a drop of sewing machine oil
every six weeks for optimal performance.
3 Rinse the cutting unit, heads and accessories under the tap. Shake them
firmly to remove water drops.
4 Let all parts dry completely.
5 Place the cutting unit back into the shaving head ('click').
6 Put protection caps or combs on the heads to prevent damage to the
heads when you store them.
7 Store the appliance, its heads and accessories in the pouch.
Note: Lubricate trimmer teeth and foils with a drop of sewing machine oil
every six weeks for optimal performance.
Replacement
To buy accessories or spare parts, visit www.shop.philips.com/service or go
to your Philips dealer. You can also contact the Philips Consumer Care
Centre in your country (see the worldwide guarantee leaflet for contact
details).
Shaving head (if supplied): For optimal performance, we advise you to
replace the cutting unit of the shaving head every two years. If you use the
shaving head twice or more times a week, replace the cutting unit more
often. Always replace the cutting unit with one of the original type (BRL384).
Body exfoliation brush (if supplied): If you use the body exfoliation brush
2-3 times a week, it lasts approximately 3 months. Replace the body
exfoliation brush every 3 months with one of the original type (BRE351).

Troubleshooting

This chapter summarises the most common problems you could encounter
with the appliance. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Centre in your country.
Problem Solution
The appliance Make sure you hold the appliance at the correct
does not work as angle (Fig. 12) and move it across the skin slowly,
well as it should. against the direction of hair growth.
Clean the heads and accessories after every use.
After charging, the The appliance is still connected to the mains. In this
battery indicator case, the battery indicator flashes to indicate that
flashes when I you should disconnect the appliance from the mains
press the on/off before you can switch it on.
button, but the
appliance does not
switch on.
During use, the The overheat protection has been activated. The
appliance overheat protection switches off the appliance
becomes hot and automatically if it becomes too hot. To reset the
suddenly stops overheat protection, let the appliance cool down and
operating. Then the then switch it on again. To avoid overheating of the
speed lights and appliance, do not press it too hard onto you skin.
the battery
indicator flash red
for 30 seconds.
My skin is irritated Slight skin irritation like red skin or red dots may
after I have used occur. This is normal. To avoid irritated skin, make
the appliance. sure that you gently move the appliance against the
direction of hair growth. Do not apply too much
pressure. If the irritation lasts longer than 3 days, we
advise you to consult a doctor.
Always stretch the skin with your free hand. When
you use the appliance on your underarms, raise your
arm and put your hand on the back of your head to
stretch the skin (Fig. 14).
Deutsch
Einführung
Herzlichen Glückwunsch zu Ihrem Kauf und willkommen bei Philips! Um die
Unterstützung von Philips optimal nutzen zu können, sollten Sie Ihr Produkt
unter www.philips.com/welcome registrieren.
Allgemeine Beschreibung (Abb. 1)
1 Griff
2 Geschwindigkeitsanzeigen (I und II)
3 Ein-/Ausschalter
4 Akkuanzeige
5 Entriegelungstaste
6 Buchse für Gerätestecker
7 Epilierkopf
8 Integriertes Licht
9 Massageaufsatz
10 Gesichtsaufsatz
11 Aufsatz für empfindliche Hautpartien
12 Hautstraffungsaufsatz
13 Scherkopf
14 Folie
15 Schermesser
16 Kamm für Scherkopf
17 Schneidekopf
18 Kamm für Schneidekopf
19 Verbindungseinheit
20 Körpermassagekopf
21 Körper-Peeling-Bürste
22 Schutzaufsatz für Körper-Peeling-Bürste
23 Reinigungsbürste
24 Ladegerät (HQ8505; Eingang: 100-240 V AC; 50/60 Hz; 9 W, Ausgang:
15 V DC; 5,4 W)
25 Pinzette mit Licht
Nicht abgebildet: Tasche
Hinweis: Die Köpfe und mitgeliefertes Zubehör kann für verschiedene
Typnummern variieren. Werfen Sie einen Blick auf die Übersicht, um zu
erfahren, welche Köpfe und welches Zubehör mit Ihrem Gerät geliefert
werden.
Laden
Hinweis: Laden Sie den Akku voll auf, bevor Sie das Gerät zum ersten Mal
benutzen.
Hinweis: Dieses Gerät kann nur ohne Kabel verwendet werden.
Um das Gerät aufzuladen, stecken Sie den kleinen Stecker in die Steckdose
an der Geräteunterseite und stecken Sie den Adapter in eine
Wandsteckdose.
- Die Ladeanzeige blinkt weiß (Abb. 2): das Gerät wird aufgeladen. Das
Laden dauert ca. 1,5 Stunden.
- Die Ladeanzeige leuchtet dauerhaft weiß (Abb. 3): das Gerät ist
vollständig aufgeladen und kann bis zu 40 Minuten lang kabellos
betrieben werden.
- Die Ladeanzeige leuchtet nicht, wenn das Gerät eingeschaltet ist: Das
Gerät weist eine ausreichende Ladung für die Verwendung auf.
- Die Akkuanzeige blinkt orange (Abb. 2): der Akku ist fast leer und muss
aufgeladen werden. Laden Sie das Gerät, wenn Sie mit dem Gebrauch
fertig sind.
Hinweis: Wenn das Gerät vollständig geladen ist, aber noch an die
Stromversorgung angeschlossen ist, blinkt die Akkuanzeige ein paar Mal,
wenn Sie den Ein/Ausschalter drücken. Dies bedeutet, dass Sie das Gerät
vom Stromnetz trennen sollten, bevor Sie es einschalten.