Table of Contents
Advertisement
3.2
Connecting to PC/ Force Recovery Mode
Step 1:
On the Host computer, open Linux terminal and enter the following command to
extract the compressed BSP image files (BSP file name may vary):
$ sudo tar -zxvf Internal.tar.gz
Note: Do not decompress the file (Internal.tar.gz) using a Windows OS, BSP should only
be decompressed in a Linux EXT3/4 file system.
Step 2:
Perform the following actions to force the system to start in USB Recovery Mode:
1.
Connect the Micro-USB plug on the USB cable to the Recovery Port on the
BOXER-8646AI, and the other end to an available USB port on the Host PC.
2.
Connect the BOXER-8646AI to a power supply.
3.
Press and hold the recovery key button. While holding the recovery key button,
power on the system, and continue to hold the recovery key button for two seconds,
then release. The BOXER-8646AI should then enter recovery mode.
4.
To check if device is in recovery mode, enter the command lsusb in terminal on
Host.
$ lsusb | grep "0955:7223"
If successful, the command will return "0955:7223 Nvidia Corp"
Chapter 3 – BSP Flash Guide
30
Advertisement
Table of Contents
