Table of Contents
Advertisement
Warm soapy water or a vinegar solution. If
Oven floor,
there are heavy deposits of dirt, only use oven
ceiling and
cleaner on cooled surfaces. Never apply to
side panels
the back panel.
Wipe with warm soapy water and a cloth. Dry
Glass cover
with a soft cloth.
for the oven
light
Soak in warm soapy water. Clean with a brush
Equipment
or sponge.
Do not clean in the dishwasher. Never use
Aluminium
oven cleaner. To prevent scratches, never
baking tray
touch the metal surfaces with a knife or a sim-
(optional)
ilar sharp object. Clean horizontally with some
washing-up liquid and a damp glass cleaning
cloth or a microfibre cloth – do not press too
hard. Dry with a soft cloth. Do not use any
abrasive materials, scouring sponges or
rough cleaning cloths. Dry with a soft cloth.
Do not use any abrasive materials, scouring
sponges or rough cleaning cloths. Otherwise,
you may scratch the surface
If a childproof lock has been fitted on the
Childproof
oven door, it must be removed before clean-
lock (optional)
ing. Soak all plastic parts in warm soapy
water and clean with a sponge. Dry with a soft
cloth. If it is very dirty, the childproof lock will
not work properly.
Refer to the hob instruction manual for infor-
Hob
mation about care and cleaning.
Cleaning the self-cleaning surfaces in the
oven
The rear panel is coated with a self-cleaning ceramic layer. This
coating absorbs and dispels splashes from baking and
roasting while the oven is in operation. You will obtain a better
result, the higher the temperature and the longer the oven is in
operation.
If soiling is still visible after several uses, proceed as follows:
First, clean the enamel surfaces in the oven.
1.
Then set
:
3D hot air.
2.
Heat the empty oven for approx. 2 hours at maximum
3.
temperature.
The ceramic coating is regenerated. Brownish and black
residues can then be removed with water and a soft sponge.
Slight colour variations of the coating have no effect on the self-
cleaning function.
Caution!
Never use abrasive cleaners. This could scratch or damage
■
the highly porous surface coating.
Do not use oven cleaner on self-cleaning surfaces. If oven
■
cleaner is accidentally applied to these surfaces, wipe it away
immediately with a sponge and plenty of water.
Detaching and refitting the rails
The rails can be removed for cleaning. The oven must have
cooled down.
Unhooking the rails
Hold the shelf frames from underneath and pull slightly
1.
forward. Pull the extension pins at the bottom of the rails out
of the mounting holes (Fig. A).
Then fold the rails upwards and carefully remove them
2.
(Fig. B).
Clean the rails with washing-up liquid and a sponge. For
stubborn deposits of dirt, use a brush.
Installing the frames
Insert the two hooks carefully into the upper holes. (Figure A-
1.
B)
:
Incorrect assembly!
Never move the frame before the two hooks are fully
anchored in the upper holes. The enamel could be damaged
and may break (figure C).
the two hooks must be inserted fully into the upper holes.
2.
Now move the frame slowly and carefully downwards and
insert in the lower holes (figure D).
Insert both frames into the side walls of the oven (figure E).
3.
If the rails are fitted correctly, the distance between the two
upper shelf positions is greater.
11
Advertisement
Table of Contents
