Using Your Sear Burner - KitchenAid 860-0012 (LP) Assembly Instructions Manual

5. Guide the lit match under the grill grate.
6. Push in and turn the burner knob to IGNITE/HIGH for
the burner closest to the lit match. The burner will light
immediately. When burner is lit, turn knob to desired
setting.
7. Repeat steps 2 trough 6 for each main burner.
8. Remove match and replace manual lighting extension on
the right side panel.
IMPORTANT:
If burner does not light immediately, turn the burner knob to
OFF and wait 5 minutes before relighting.
If any burners do not light after attempting to light them
manually, contact the Customer Service Center. See the
" Assistance" section.
Using Your Sear Burner/Rear Burner
Lighting the Sear Burner/Rear Burner
1. Open the burner cover. Do not light burners
with the cover on.
2. Do not lean over the grill.
3. Push in and turn the grill control knob to IGNITE/HIGH, while
continuing to hold it in.
IMPORTANT: If burner does not light immediately, turn the
burner knob to OFF and wait 5 minutes before relighting.
Manually Lighting The Sear Burner or Rear Burner
1. Open the hood completely. Do not light burners with the
hood closed.
2. Do not lean over the grill.
3. Remove the manual lighting extension (see the following
illustration) and attach a match to the split ring.
4. Strike the match to light it.
5. Hold the lit match close to the burner.
Sear Burner
6. Push in and turn the control knob to IGNITE/HIGH.
For the burner closest to the lit match. The burner will
light immediately. When burner is lit. turn knob to
desired setting.
7. Repeat steps 3 through 6 for each burner.
8. Remove the match and replace the manual lighting
extension on the right side panel.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to light them manually,
contact the Customer Service Center. See the ''Assistance''
section.
Rear Burner
25