Problem Of Windows Stop Error; Problem Of Raid System - NEC EXP801 Maintenance Manual

Chapter 1 Maintenance
5.5

Problem of Windows STOP Error

[?] Cannot turn the power OFF at the blue screen (STOP error screen)
→
Perform the forced shutdown (continue to press the power switch for at least four seconds) to turn off
the server.
5.6

Problem of RAID System

[?] Unable to rebuild the RAID array
 Is the capacity of the hard disk drive to be rebuilt enough?
→
Use a hard disk drive with the same capacity as that of the faulty hard disk drive.
 Is the logical drive RAID0?
→ RAID0 cannot be rebuilt because it has no redundancy.
[?] Unable to automatically rebuild the RAID array
 Did you wait for sufficient time until the hard disk drive was replaced?
→
Follow the steps below to use the auto-rebuilding feature.
(1) Remove a failure HDD.
(2) Wait for at least 90 seconds.
(3) Install a new HDD.
[?] Unable to perform Consistency Check
 Is the logical drive Critical or Degraded?
→
Replace the failed hard disk drive with new one, and then perform Rebuild.
 Is the logical drive RAID0?
→ RAID0 has no data redundancy and Consistency Check is disabled in the RAID0 array.
Express5800/R120g-1M, R120g-2M Maintenance Guide
5. Troubleshooting
35