Bosch GCM18V-12GDCN Operating/Safety Instructions Manual page 38

1609B06757.qxp_GCM18V-12GDC 3/25/20 12:35 PM Page 38
Workpiece Support
CLAMPS
Using the Workpiece Clamp
30
clamp cannot be used. Support workpiece
with your hand outside the "No Hands"
zone. Do not try to cut short pieces that
cannot be clamped and cause your hand
to be in the "No Hands" zone.
dry run with the saw Off by conducting a
simulated cutting cycle, and observe the
projected path of the saw blade. Keep
hands at least six (6) inches (152mm)
away from the projected path of the saw
blade.
Clamps
SLIDING FENCES
from hand to saw blade, extend the sliding
fences and sliding base extensions when
making extreme bevel, miter, or com-
pound cuts (Fig. 32).
Operating Sliding Fences
38
.800.544.2843
Preparing for Saw Operations
There may be extreme
compound cuts where
Be aware of the path of
the saw blade. Make a
To provide sufficient
(minimum 6") spacing
www.calcert.com
15
10 20
5 25
30
0
30
Workpiece
Fig. 35
39
39
Removing Sliding Fences
Fig. 34
Fence
Lock Knob
Tethering
Cable
sales@calcert.com