Black & Decker BXAC40018GB Original Instructions Manual page 9

Assembling Your 3-in-1 Air Conditioner
WARNING: Before performing any assembly or
maintenance, switch the unit off and remove it from
the power supply.
Using the Window Kits
This unit comes equipped with two separate window
kits, suitable for sash and casement windows,
respectively.
Step One
Step Two
Installing the Casement Window Kit
To install the casement window kit, carry out the
following steps:
♦
Place the included adhesive tape all around
Window Casement Kit
the inner and outer perimeters of the window,
as shown in the illustration below. Be careful to
Adhesive Tape
ensure the tape is applied to both sides.
Step One
Adhesive Tape
♦
Once the tape has been correctly installed, use
the adhesive fasteners on the window kit to attach
it to the adhesive, as shown in the illustration
above. If necessary, tie up the remainder of the
window kit so that it is not loose, taking care to
ensure there are no gaps between the tape and
the adhesive.
Step One
Step One
Adhesive Tape
Adhesive Tape
Adhesive Tape & Casement Window Kit
Step Three
Step Two
Window Casement Kit
(Original instructions)
Step Two
Step Two
Window Casement Kit
Window Casement Kit
♦
Once the window kit is in position, open the zipper
in the middle and slot the air conditioner's hose
through it.
Step Four
♦
Once the hose is correctly installed, close the
zipper tightly around it to secure it into place.
Note! Ensure the hose is attached to the air
Step Three conditioner before attempting to use the unit.
Step Four
♦
The unit is now ready for normal use.
ENGLISH
Step Three
Step Three Step Four
Step Four
9