Installing And Removing Drives In The Lower Bay (Optional); Installing And Removing A 3½ Inch Drive Or A 3½ Inch Adapter - Fujitsu CELSIUS J550 Operating Manual

Installing and removing drives in the
lower bay (optional)
In the lower bay you can install a non-accessible 3½ inch drive, two non-accessible 2½
inch drives with a 3½ inch adapter or a non-accessible 2½ inch drive.
Depending on the type of drive, fixing to the casing is either by EasyChange rails or by screw fastening.
Installing and removing a 3½ inch drive or a 3½ inch adapter
The following procedure describes installation and removal using the example of a 3½ inch drive.
The approach is the same for all variants. Any differences are indicated accordingly.
Installing a drive
► Remove the casing cover (see Chapter
► Fold out the drive cage (see chapter
EasyChange rails for the drive are located in the lower bay.
a
► Fasten the EasyChange rails to the side of the drive or adapter by inserting each pin of
the EasyChange rail in the corresponding holes on the drive. In doing so, make sure
that the ports on the drive are located at the rear as shown (a).
Fujitsu
"Removing the casing cover", Page
"Opening the drive cage", Page
System expansions
35).
46).
51