Sharp SPC658 Instruction Manual & Warranty

Thank you for your purchase of this quality clock. The utmost care has gone into the design and manufacture of your
clock. Please read these instructions and store them in a safe place for future reference.
FEATURES
1. PM indicator
2. POWER ON/OFF button
3. VOL - button
4. PLAY/PAUSE/
SNOOZE button
5. VOL + button
6. Bluetooth indicator
7. Alarm indicator
8. HOUR button
9. MIN button
10. AUX IN jack
11. DC 5V jack
12. Battery compartment
13. ALARM ON/OFF switch
14. ALARM button
15. Speaker
16. TIME button
CONNECTING TO THE POWER SUPPLY
Insert the AC adaptor into a 120V AC ~ 60Hz mains outlet and the other end of the cord into the DC 5V jack on the
back of the unit.
INSTALLING THE CLOCK & ALARM BACK UP BATTERIES
The clock time and alarm time (if set) can be maintained during a power failure by 2 x AAA/ LR03 batteries (not
supplied). However, once the power is restarted, check the time to make sure it is accurate and reset if necessary.
INSERTING THE BATTERIES
1. Open the battery compartment at the back of the unit by pressing on the catch and removing the cover.
2. Insert 2 x AAA/ LR03 batteries (preferably alkaline batteries) into the battery compartment, following the polarity
as shown on the diagram inside the compartment.
3. Replace the battery compartment cover.
SETTING THE CLOCK
- Press and hold the TIME button down to activate time setting.
- While holding down the TIME button, press the HOUR button to advance to the correct hour. The PM indicator will
light when the hour is advanced into the PM time.
- While holding down the TIME button, press the MIN button to advance to the correct minute.
- Release the TIME button when the correct time is shown on the display.
SETTING THE ALARM
- Press and hold the ALARM button down to activate alarm setting.
- While holding down the ALARM button, press the HOUR button to advance to the correct hour. The PM indicator
will light when the hour is advanced into the PM time.
- While holding down the ALARM button, press the MIN button to advance to the correct minute.
- Release the ALARM button when the correct alarm time is shown on the display.
USING THE ALARM FUNCTION
- Slide the ALARM ON/OFF button to ON to activate the alarm and the alarm indicator will be lit.
- Slide the ALARM ON/OFF button to OFF to deactivate the alarm and the alarm indicator no longer be visible.
SNOOZE FUNCTION
- Pressing the SNOOZE button after the alarm sounds will cause the alarm to stop and the alarm will sound again in
9 minutes. This will happen each time the SNOOZE button is pressed.
USING BLUETOOTH FUNCTION
- Press the POWER ON button to enter Bluetooth mode. The Pairing Indicator will flash blue quickly.
When pairing, remain within 3 feet of the unit.
- Using the native controls on your Bluetooth device, select the "SPC658" in your Bluetooth settings to pair.
SPC658 LED Alarm Clock with Bluetooth
Instruction Manual & Warranty
1 2 3 4 5 6 7 8 9 10 11 12 1314 15 16