Kenmore 146.20164510 Use & Care Manual page 24

Sideburner
□ Loosen side burner in side shelf. (B ). To loosen, unscrew and remove two front screws holding
sideburner in place. (A). Note: Do not loosen electrode screw.
□ Remove the 2 pre-installed screws from the valve stem and set them aside. (C)
Insert valve stem through hole in fascia. (D) Install previously removed 2 screws .Note:Do not tighten
these 2 screws until the bezel is attached to fascia and valve face.(E).
□ Attach bezel to facial and valve face with the installed screws .Firstly attach one side key hole of
bezel to the screw ,then attach the other one to the other screw.Make sure the black mark facing
up.(F). Tighten the 2 screws .(G)
□ Place sideburner tube over the valve, making sure that valve is inside sideburner tube. (H)
□ Push control knob onto sideburner valve stem. (I)
□ Reattach sideburner to sideburner shelf with the 2 previously removed screws. Replace sideburner
grate. (J)
□ Insert the small tips of the four main control panel wires into four of the five module sockets. Insert the
small tip of the side burner wire into the fifth socket. For the other wire with larger tips, attach the
two-wire tip to the module bare terminal. Attach the other tip to the terminal on top of the sideburner
control valve.(K)
□ Unscrew igniter cap from control panel. Insert (1) AA battery (provided in blister pack) into battery
slot with positive end (+) facing outward. Screw igniter cap back onto panel. (L)
A
A
C
C
E
E
G
24 •23678-41100309
B
B
D
D
F
F
H