Switch Action - Makita LH1040F Instruction Manual

1
2
3
005539
To adjust the bevel angle, loosen the lever at the rear of
the tool counterclockwise.
Push the handle to the left to tilt the saw blade until the
pointer points to the desired angle on the bevel scale.
Then tighten the lever clockwise firmly to secure the arm.
CAUTION:
When tilting the saw blade, be sure to raise the
•
handle fully.
After changing the bevel angle, always secure the
•
arm by tightening the lever clockwise.

Switch action

2
005540
CAUTION:
Before operation, make sure that the tool is turned
•
on and off.
To start the tool, press the ON ( I ) button. To stop it, press
the OFF ( O ) button.
Lighting up the lamps
For Model LH1040F only
1
005541
Push the upper position of the switch for turning on the
light and the lower position for off.
1. Lever
2. Bevel scale
3. Pointer
1. Switch
2. Lamp switch
1
1. Lamps
CAUTION:
Do not look in the light or see the source of light
•
directly.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Adjusting the level of top table
012648
To adjust the level of top table, loosen two levers by
turning counterclockwise and then raise or lower the top
table. Tighten these levers firmly after the adjustment.
WARNING:
Position the top table at the topmost position when
•
using the tool in the miter saw mode and at the
desired position when using in the table saw mode
(bench mode).
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing saw blade
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the blade.
Use only the Makita socket wrench provided to
•
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening of
the hex bolt. This could cause an injury.
Secure the top table at the topmost position.
Lock the handle in the raised position by pushing in the
stopper pin.
9
1. Lever
1