JVC LT-65C880C Quick Start Manual

Quick Start Guide
65" LED Smart 4K HDR TV
LT-65C880(C)
JVC 65' LED Smart 4K HDR TV LT-65C880(C) Quick Start.indd 1-3
Thank you
for purchasing your new JVC TV.
Your new TV incorporates the latest technology to enhance your viewing
experience. We would suggest that you allow about 15 mins for initial setup.
Please follow this guide for a successful first time installation.
1
Setup in
What's in the Box?
15mins
Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.
TV Remote Control/
AAA Batteries x2
Right Foot
Feet Screws x 6
Left Foot
2
Operating Your Remote Control
1. Slide open the battery compartment on the back of the remote control.
2. Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends of the
batteries with the (+) and ( - ) ends indicated in the battery compartment.
3. Slide the battery compartment cover back into place. Make sure it clicks into place.
3
Installing the Base Stand
Fitting the Feet to the TV
1. Ensure the TV is switched off and not connected to the mains power supply.
2. Keep the protective bag on the TV to protect it.
3. Make sure you have some help, this requires 2 people. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly
overhangs the edge of the table, with the back side facing up. Please make sure a soft cushioned material (such as a dry bath towel or thick piece of foam) is
placed beneath the screen. Be very careful not to knock the edges of the TV, the screen is very fragile.
4. The feet are marked up as Left and Right. They can only be attached with the right foot on the right side of the TV as you look from the back and the left on the
left side. Attach each foot with 3 of the supplied screws.
Protective
Bag
Cushioned
material
Left Foot
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object, or
anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because the
screen could crack.
The latest eco-friendly power-saving technology will switch off the TV if
it is left on and idle for 4 hours. Please refer to "Auto Standby" under the
"Time Settings" section of the instruction manual for more detail.
Instruction Manual
Please inspect your TV for damage after unpacking. If
Quick Start Guide
you do notice any damage please consult your dealer.
Table
Right Foot
4
Connecting the Aerial and Turning on the TV
1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the ANT socket on the back of your TV.
2. Plug the TV into a mains socket and switch on at the mains.
3. In standby mode, press the button on the remote control to turn the TV on. The LED indicator will flash for a few seconds then the TV will switch on.
VGA LAN Optic.OUT ANT HDMI 1
.
RF coaxial cable
(not included)
Router
(not included)
Optional
If you want to connect to the internet via a wired connection
then connect your ethernet cable to the LAN socket.
• Do not connect the TV to the mains supply until you have completed all the connections.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.
To completely disconnect the mains power, please remove the mains plug from the mains socket.
07/11/2018 10:57