Power On And Power Off The Camera Unit; Power On The Camera Unit - Panasonic AW-UE20WP Operating Instructions Manual

Power on and Power Off the Camera Unit

Power on the Camera Unit

When performing the operations using the wireless remote control.
Set all the power switches of the units and devices connected in the system to ON.
When the power is supplied, the status display lamp lights orange. After the initial setting is
completed, it switches to green and the power turns on.
[Note]
 During the initial settings operation, the unit cannot be operated.
 The unit stores its STANDBY / POWER ON mode status in the memory.
 If the power supply is cut off while the operation is in POWER ON mode, the operation will transfer
to the POWER ON mode the next time power is supplied.
 When transferring to the STANDBY mode
- Status indicator LED: Orange
- When operation is transferred to the standby mode: The current pan-tilt position is stored in the
memory (as a POWER ON preset), and the panning/tilting moves so that the camera points in
the backward-facing direction.
 When transferring to the POWER ON mode
- Status indicator LED: Green (after the initial setting operation is completed))
- The pan/tilt unit is moved to the position which was stored in the memory when the transition to
the STANDBY mode was made.
 POWER ON preset
- The pan/tilt unit is moved to the setting, which was established immediately prior to the transition
to the STANDBY mode, when the power has been turned on.
 If the power is turned off without transferring to the STANDBY mode, the pan/tilt unit position will
not be stored in the memory or reflected in the POWER ON preset. The previous POWER ON
preset will be applied.
When performing the operations using the controller (AW-RP60, AW-RP150).
For details, refer to the operating instructions for the controller.
88