Table of Contents
Advertisement
16
OPERATING INSTRUCTIONS & CARE AND CLEANING
e. Make sure the hose is secure so there are
no leaks.
f. Direct the hose toward the drain, making
sure that there are no kinks that will stop
the water flowing.
g. Place the end of the hose into the drain.
(fig.4)
h. Select the desired humidity setting and
fan speed on the unit for continuous
draining to start.
1. Check the seal between the hose and the
drain connector. If there is a small leak
then
re-tighten the hose.
2. It is recommended that a Dehumidifier
Drain Hose - 1/2" (12.7 mm) or larger be
used. Make sure there are no kinks or
elevations in the hose.
3. When a hose is not attached to the drain
connector, please ensure drain cap is
screwed securely to the connector to
prevent leakages.
fig. 3
Care and Cleaning
1. Filter
Clean the filter every two weeks based on
normal operating conditions.
To remove the filter:
a. Open the back grille.
b. Detach the filter from the back of the grille
by pressing the tabs as shown below.
fig. 4
NOTE
replace
the
hose
gasket
and
Advertisement
Table of Contents
