Advertisement
Quick Links
Advertisement
Related Manuals for NCR External CX Keypad Module
Summary of Contents for NCR External CX Keypad Module
- Page 1 Kit Instructions External CX Keypad Module 7772-K149 Issue A...
-
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. -
Page 3: Kit Contents
External CX Keypad Module This kit provides an external keypad module for the NCR CX7 All-in-One POS (7772). Kit Contents... -
Page 4: Installation Procedure
External CX Keypad Module Installation Procedure Warning: Disconnect the AC power cord from the AC outlet and wait 30 seconds before servicing the terminal. 1. Lay the Display face down on a flat surface. Note: Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down. - Page 5 External CX Keypad Module 3. Disconnect the Cables. a. Loosen the thumbscrew of the 180-degree USB-C Cable then disconnect the Cable. b. Remove the Ethernet Cable from the Cable Management Hook then disconnect the Cable. 4. Loosen the two (2) captive screws that secure the Back Cover to the Display.
- Page 6 External CX Keypad Module 5. Rotate the Back Cover away from the Display and unhook the Back Cover Tabs. 6. Route the Keypad Cable through the Port opening.
- Page 7 External CX Keypad Module 7. Route and secure the Cable under the Cable Management Hooks as shown, then connect the Cable to the Motherboard (USB Port A). 8. Pull the excess cable through the Port opening and align the Keypad mounting holes...
- Page 8 External CX Keypad Module 9. Secure the Keypad with two (2) screws. 10. Tuck the excess cable in the location shown.
- Page 9 External CX Keypad Module 11. Install the Keypad Back Cover. a. Insert the Keypad Back Cover Tabs into the openings in the back of the Keypad and snap into place. b. Secure the Keypad Back Cover with two (2) screws.