Tool Description - HP ProLiant DL580 G7 Product End-Of-Life Disassembly Instructions

Gas Discharge Lamps
Plastics containing Brominated Flame
Retardants
Components and parts containing
toner and ink, including liquids, semi-
liquids (gel/paste) and toner
Components and waste containing
asbestos
Components, parts and materials
containing refractory ceramic fibers
Components, parts and materials
containing radioactive substances
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a
point where components and materials requiring selective treatment can be removed.

Tool Description

Torx screw driver
Flat head screw driver
Philips Driver
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials
requiring selective treatment:
1. System Board Battery - Remove the top cover and locate the battery on the system
board. Use a medium flat head screwdriver or fingers to remove the battery and
dispose of properly
2.
BBWC Battery – With a medium flat head screw driver remove the BBWC battery and
dispose of properly.
3.
Capacitors=>2.5CM - Remove the power supply from the system using a T-15 driver. With
#2 Philips screw driver, remove the screws securing the top cover, then locate the capacitors
and pry from the PCB with a medium flat head screw driver and dipose of properly.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below
to identify the items contained in the product that require selective treatment (with descriptions
and arrows identifying locations).
Attachment 1 – System Battery Location
Attachment 2- Location of BBWC Battery
Attachment 3,4,5- Capacitor location by model number of supply
Include the cartridges, print heads,
tubes, vent chambers, and service
stations.
Tool Size (if applicable)
T15
Medium
# 2
0
0
0
0
0
0