Philips PSA200 Firmware Upgrade Manual

Philips psa200: software guide

Hide thumbs Also See for PSA200:

Download this manual See also: User Manual

PSA200 Firmware upgrade procedure

1. Download the zip file from the site. Then unzip the file into a temp folder on your

computer.

2. At Start->Programs->Nike->psa200, select and launch "Upgrader".

3. When the user starts the Upgrader with no device connected, the following screen

Start

is seen with the

• The

Start

button is enabled only when the correct device is connected

• Click on the"..." button to browse and select the unzipped firmware file to be

loaded into the device and then click open

- Place a fresh battery to the set and connected to the PC

• The user is informed that the device will be upgraded with the new firmware.

On pressing OK, the firmware is loaded.

• Disconnect the device so that the device upgrades to the new firmware

button disabled.

Page 1 1. Download the zip file from the site. Then unzip the file into a temp folder on your computer. 2. At Start->Programs->Nike->psa200, select and launch “Upgrader”. 3. When the user starts the Upgrader with no device connected, the following screen...
Page 2 -Press the play key and the LCD display shows :” FUpgrade” -Wait until the set switch off automatically. -The set is then upgraded.