Advertisement
ENGLISH
(Original instructions)
Power Supply
Your adaptor has been designed for a specific
voltage. Always check that the mains voltage
corresponds to the voltage on the rating plate.
WARNING: Never attempt to replace the adaptor
unit with a regular mains plug.
♦
If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised
BLACK+DECKER Service Centre in order to avoid
a hazard.
♦
Do not expose the adaptor to water.
♦
Do not open the adaptor.
♦
Do not probe the adaptor.
Electrical safety
Symbols on the power supply
Read all of this manual carefully before
using the appliance.
This appliance is double insulated;
therefore no earth wire is required.
Always check that the power supply
corresponds to the voltage on the rating
plate.
The power supply is intended for indoor
use only.
Labels on appliance
♦
The following symbols appear on this appliance
along with the date code.
Read all of this manual carefully before
using the appliance.
6
Features (see page 2)
Fan
1.
Air Purification Light Indicator
2.
Fan Indicators
3.
Fan Button
4.
Air Purification Button
5.
Air Inlet
6.
Adapter Socket (back of unit)
7.
Use
About the Controls
♦
3 fan speed settings - High/ Medium/ Low
♦
Air Purification Setting
How to Operate
♦
Place the unit on a firm and level surface.
♦
Plug the adapter into the socket in the underside
at the rear of the unit.
♦
Plug the power cord into an active mains outlet.
♦
Switch the power on at the socket. The lower of
the fan indicator lights will flash and the unit will
enter stand-by mode.
♦
Choose to leave the fan down or raised to 90°.
Fan Settings
♦
Press the Fan button to activate the fan. The first
fan indicator light will illuminate constantly.
♦
Press the Fan button again to cycle through
the 3 speed settings, returning to standby. The
corresponding fan indicators will illuminate.
Note:
When the fan is operating at Low or Medium
setting, press and hold the Fan button for 2 seconds
to turn the fan function off.
Advertisement
