Table of Contents
Advertisement
6. DIAL AND BUTTONS
6.1 On/Off
Pressing this button for a few seconds
allows to activate or deactivate the
appliance. Two different tunes sound
while switching the appliance on or off.
As the Stand-by function automatically
deactivates the appliance to decrease
the energy consumption in a few cases,
you may need to activate the appliance
again.
For more details, refer to Stand-by
paragraph in Daily Use chapter.
6.2 Introduction
The options/functions are
not selectable with all
washing programmes. Check
the compatibility between
options/functions and
washing programmes in the
"Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allow you
to set the incompatible
options/functions together.
Make sure the screen and
touch buttons are always
clean and dry.
6.3 Temp.
When you select a washing programme,
the appliance automatically proposes a
default temperature.
Touch this button repeatedly until the
desired temperature value appears on
the display.
When the display shows the indicators
and
heat the water.
6.4 Centrif.
When you set a programme, the
appliance automatically sets the
maximum spin speed allowed.
Touch repeatedly this button to:
• Decrease the spin speed.
, the appliance does not
The display shows only
the spin speeds available
for the set programme.
• Set the Drenar option (Skipping the
wash, rinse and spin phases) .
The appliance performs the only
draining phase of the selected
washing programme.
The display shows the indicator
(cold), and the indicator
spin) and the indicator
• Set the Centrif. option (Skipping the
wash and rinse phases) .
The appliance performs only the
spinning phase of the selected
washing programme.
The display shows the indicator
(cold), the phase indicator
spin speed.
If it is necessary to reduce
the spin speed, select a
programme with a lower
spin speed as default.
6.5 Manchas/Pre-Lav.
Press this button repeatedly to activate
one of the two options.
The relevant indicator goes on in the
display.
• Manchas
Select this option to add an anti-stain
phase to a programme in order to
treat heavily soiled or stained laundry
with stain remover.
Pour the stain remover into
compartment
will be added in the appropriate
phase of the washing programme.
This option is not
available with a
temperature lower than
40 °C.
• Pré-lavado
Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
ENGLISH
15
(no
.
and the
. The stain remover
Advertisement
Table of Contents
