Lucent System 25 - NEC NVM-CA Series Integration Manual

Lucent System 25

Integration Notes
Required Hardware and Software
3
3
3
3
Voice Mail Availability
Phone System Programming
To have the the Voice Mail Automated Attendant answer incoming
trunks:
Issue 1-0
CPU/MEM Card ZTN129, ZTN130, or ZTN142
ZTN78 Tip and Ring Line Card (All Versions), OR
ZTN742 Analog Line Card (Version 17 or higher)
Each the Voice Mail port that you want to use must be connected to an analog port on one of
these cards. An analog port that is connected to the Voice Mail will be referred to as a VM ana-
log port. Its corresponding extension no. will be referred to as a VM analog extension.
Version R2 or Higher. The phone programming shown below is derived from System 25
Administration Terminal Software.
This phone system is available on the NVM-2000CA with Software Version 8.01 or higher.
MAIN MENU, Auxiliary Equipment, Voice Messaging System
This programming identifies which of the VM analog ports should answer incoming trunks.
1. In the C/SS/PP fields, enter this information for each VM analog port that should answer
trunks: the cabinet number (C), the station slot number (SS), and the actual port number
(PP), press Enter.
2. In the Board Type field, use the spacebar to select Coverage/Auto-Attendant for each port.
3. Press Enter to reach the Voice Messaging System Option screen.
4. Make the following entries in the fields below:
3
In Assign PDC for this VMS port (1-9999), enter the extension number for the station
port
3
In Make VMS Port Dial Accessible, enter Yes.
3
In Make VM port an Extended Station, enter No.
3
In Display ID for this VMS port, enter VMAIL.
3
In Answer these Directed Night Service Trunks:
If you want the Automated Attendant to answer any trunk that rings this port while the
system is in the Night Mode, press Enter. Then enter the trunk number on the
TRUNKS screen.
Integration Notes
Lucent System 25
X
137