Maintenance - Husqvarna 1-8DPS30 Operator's Manual

8. Make sure that the hotspot is equaly applied on the
surface for correct adjustment.
9. Tighten the adjustment lever and the 3 nuts when
the control cage is in correct position.
To stop the product
1. Push the abrasive control cable to close the abrasive
To operate the abrasive valve on
valve. Refer to
page 11 .
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 6 .
WARNING:
maintenance, stop the motor and disconnect
the power plug from the power supply. Make
sure that all drives stop.
18

Maintenance

Before you do
Use personal protective
Personal protective
Before you do the
2. Push the OFF button to stop the blast motor.
3. Turn the ON/OFF switch to the OFF position.
4. Disconnect the power plug from the power supply.
5. Stop the dust extractor. Refer to the operator's
manual of the dust extractor.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarnaconstruction.com.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
2087 - 001 - 23.02.2023