Connecting With The The Professional Puncher Integration Unit - Canon Saddle Finisher-AF2 Service Manual

[1]
9) Install the rear small cover.
10) Install the shunt cable [1].
- 2 screws (RS tightening; M4X10) [2]
[2]
[1]
2.3.6 Connecting with the the Professional Puncher
Integration Unit
CAUTION:
Be sure the power of the host machine is turned OFF and the power plug is
disconnected from the outlet.
1) Install latch plate (for front) [1] (for rear) [2] in the Integration Unit upper
left stay.
- 4 screws (RS tightening; M4X10) [3]
CAUTION:
Confirm the engraved mark on each latch plate when attaching.
For front [1]: F
For rear [2]: R
[2]
F-2-33
[2]
F-2-34
[2]
[3]
2) Install positioning screw [1].
- 2 screws (RS tightening ; M4X10) [2].
[1]
[2]
0020-6813
3) While lifting latch mount (front) [1], fit the Integration Unit side's posi-
tioning pin [2] into positioning board's hole [3] of the Finisher, to connect
the Finisher with the Integration Unit.
<Front side>
R
[2] [1]
[1]
[3]
F-2-35
[1]
F-2-36
Chapter 2
F
2-11