Related Manuals for P. M. Lighting Professional CS Series
Summary of Contents for P. M. Lighting Professional CS Series
- Page 2 CS936-LED Copper Area/Path Lights† Landscape Cable 14/2 gauge* CS937-LED Copper Bullet Directional Lights† 1 each Outdoor Timer with Photocell CS933-LED In-Ground Well Lights‡ 1 each Stake Driver Cap (Installation Tool) 1 each CS Pro-Series Transformer Screwdriver (Flat & Phillips Head) Shovel Wire Cutter Hammer...
- Page 3 Use the Easy Design Guide to help determine the best way to wire your fixtures to create optimal results in the illumination of your home. Follow these simple rules for best results: 1. It is recommended that you use 2 MAIN SUPPLY CABLE runs from the transformer for best results and easiest installation, especially when you need to install fixtures on both sides of the transformer.
- Page 4 This example demonstrates the optimal wiring plan design, using two (2) Main Supply Cables from the transformer to split the fixtures into two (2) groups. For best results follow these tips: 1. Keep cables as short as possible. 2. Leave enough slack to make burying cable easier. 3.
- Page 5 For use with Low Voltage Landscape Lighting Power Units. FOR OUTDOOR USE ONLY. Amperage not to exceed 25 AMPS per circuit Voltage not to exceed 15 VOLTS per circuit Warning: Luminaire must be installed in accordance with the National Electric Code (NEC) and all Local Codes. Failure to comply with NEC and/or Local Codes may cause serious injury and could destroy the luminaire.
- Page 6 For use with Low Voltage Landscape Lighting Power Units. FOR OUTDOOR USE ONLY. Amperage not to exceed 25 AMPS per circuit Voltage not to exceed 15 VOLTS per circuit Warning: Luminaire must be installed in accordance with the National Electric Code (NEC) and all Local Codes. Failure to comply with NEC and/or Local Codes may cause serious injury and could destroy the luminaire.
- Page 7 For use with Low Voltage Landscape Lighting Power Units. FOR OUTDOOR USE ONLY. Amperage not to exceed 25 AMPS - Voltage not to exceed 15 VOLTS Warning: Luminaire must be installed in accordance with the National Electric Code (NEC) and all Local Codes. Failure to comply with NEC and/or Local Codes may cause serious injury and could destroy the luminaire.
-
Page 9: Input Connection
CS Pro Series Transformer Installation Instructions The CS ProSeries Transformer must be plugged in to a 120VAC GFCI protected outlet. Unplug transformer from outlet prior to installation and during service! For all wire connections: Use UL listed Wire Connectors included with the fixtures and kit. For all the opened knockouts: Use UL listed Cable Clamp suitable for the cable size and type (included with kit). - Page 10 To further clarify installation and wiring of your CS Professional Series power transformer, please refer to the instructions below. 1) USE ONLY THE BOTTOM SCREW TERMINALS TO ATTACH THE MAIN CABLES FROM THE LIGHT FIXTURE RUNS. DO NOT LOOSEN TOP SCREWS OR REMOVE WIRES ATTACHED TO THE TOP SCREWS. LOOSENING THE TOP SCREWS MAY CAUSE THE TERMINAL BLOCK TO LOSE POWER TO THE TRANSFORMER COIL.
- Page 11 Strip Length Approx. ¾” Left Right Wire Wire • Each 14/2 main cable must be split in the middle to create a left and right side. • Strip the outer insulation from each wire approximately ¾” of an inch to expose the copper stranded wires Left Right...