Operation - Makita DHS782 Instruction Manual

For tool with the ring
1 2
15.88
1. Mounting shaft 2.
blade 4.
WARNING:
BE SURE TO TIGHTEN THE HEX
BOLT CLOCKWISE SECURELY. Also be careful
not to tighten the bolt forcibly. Slipping your hand
from the hex wrench can cause a personal injury.
WARNING:
If the ring is needed to mount the
blade onto the spindle, always be sure that the
correct ring for the blade's arbor hole you intend
to use is installed between the inner and the outer
result in the improper mounting of the blade causing
blade movement and severe vibration resulting in
possible loss of control during operation and in seri-
Blade guard cleaning
When changing the circular saw blade, make sure to
also clean the upper and lower blade guards of accu-
mulated sawdust as discussed in the Maintenance
lower guard operation before each use.
Connecting a vacuum cleaner
a hose of the vacuum cleaner to the dust nozzle as
1
2
1. Dust nozzle 2. Screw
6
4
3
3. Circular saw
5. Hex bolt 6. Ring
5
1. Hose 2. Vacuum cleaner

OPERATION

This tool is intended to cut wood products. With appro-
priate Makita genuine circular saw blades, following
materials can also be sawed:
• Aluminum products
for the correct circular saw blades to be used for the
material to be cut.
Checking blade guard function
Set the bevel angle to 0°, and then retract the lower
drance and;
stopper.
2
3
1. Upper guard 2. Lower guard 3. Base 4. Stopper
5. Open 6. Close
saw dust is accumulated inside of the upper and lower
Makita service center.
13 ENGLISH
2
1
1
5
6
3
2
-
1
4