Using Webbrowser; Projector Settings; Computer Settings - Panasonic PT-LB20NTU User Manual

Using WebBrowser

Connect the projector and computer before taking the steps below.
(See page 12 or page 32)

Projector settings

1
Select [WEB CONTROL] on the network menu
2
Select [ON] or [OFF] with the [
WEB CONTROL
ON: This enables control on the WebBrowser.
OFF: This disables control on the WebBrowser.
Note:
The WebBrowser password is not set at the factory, and should be set on the
WebBrowser. In addition, if you forget the password, select [DEFAULT] at the
network menu and initialize the network settings. (See page 37)

Computer settings

1
Click [
2
Change the projector settings by WebBrowser.
Make the SSID, communication mode, IP address, subnet mask and WEP
settings, and then quit WebBrowser.
Notes:
• When the projector settings have been changed using a WebBrowser, the
projector will not appear on the connection list until the projector network is
switched to [USER].
• After the projector network has been switched to [USER], manually release the
proxy settings of the WebBrowser used.
] on the launcher
] buttons.
.
(See page 15)
38
(See page 28)
N E T W O R K
NETWORK
NAME CHANGE LB20NT
INPUT PASSWD OFF
AMEND PASSWD
WEB CONTROL ON
STATUS
DEFAULT
ENTER
SELECT
.
1
RETRN