Panasonic PT-F200 Network Manual page 24

Connecting with wireless LAN
Computer settings
Turn on the computer and log on with the administrator authority.
4
Click [Start] [Control Panel]
Network Connections], and click [Properties], then <Wireless Network Connection Properties> window appears.
Select [Internet Protocol (TCP/IP
5
※"Glossary" (See page 70)
<Internet Protocol (TCP/IP) Properties> window appears.
Select [Use the following IP address] on [General] tab, enter the IP address and
6
Subnetmask, and click [OK].
Make the IP addresses of the upper three of the four break points the same value as that of the projector, and change
the value of the last break point alone.
Make the Subnetmask as the same value as that of the projector.
Click [Wireless Networks] of [Preferred networks] on [Wireless Networks] tab in
7
<Wireless Network Connection Properties> window.
[Wireless network properties] window appears.
When the [Wireless Networks] tab does not appear, refer to page 75.
Make the SSID, network authentication, data encryption and communication mode
8
settings the same as those of step 3, and click [OK].
Click [OK] in <Wireless Network Connection Properties> window.
9
The connection with the projector is established.
10
Click [Start] [Log Off] and log off from the computer.
Computer operation
11
Log on with the user who operates Wireless Manager ME 4.5.
Start Wireless Manager ME 4.5.
12
Select the desired projector in the [Detailed] screen of the <Select Access Port>
13
window and click [OK].
The launcher appears and the connection with the projector is established.
("Description of the launcher"
If the projector is not displayed, click [Designate] followed by [ADD], then enter the IP address set in the projector using
the <Access Port Registration> window, and click [REGISTER]. (See page 30)
(cont.)
[Network and Internet Connections]
※ )] on [General] tab, and click [Properties].
See page 33)
24
[Network Connections], right click [Wireless