Troubleshooting; Washer - LG Studio WashTower SWW 50 3 Series Owner's Manual

en-us_main.book.book Page 54 Monday, January 9, 2023 5:59 PM

54 TROUBLESHOOTING

TROUBLESHOOTING
The appliance is equipped with an automatic error-monitoring system to detect and diagnose problems at
an early stage. If the appliance does not function properly or does not function at all, check the following
before you call for service.

Washer

FAQs: Frequently Asked Questions
Q: Why does my washer make loud banging noises while it is filling with water?
A: This is actually a problem with the plumbing in your home. When the water valve in the washer shuts
off, it can cause pipes in your home to move, resulting in a loud banging noise. This effect, called
water hammer, can be reduced by installing an item called a water hammer arrestor. Add-on
arrestors can be purchased through your local hardware or home improvement store.
Q: Why is there so little water in my washer? How can it clean the clothes?
A: HE (High-Efficiency) washers are designed to properly wash your laundry while using a minimum
amount of water and energy. Because the water volume is low, the small amount of detergent used is
more concentrated in the water, resulting in excellent cleaning performance.
Q: When I press a button, why does my washer beep and then nothing happens?
A: The Control Lock feature is turned on. To turn it off, turn on the product, then press and hold the lock
icon on the display for 3 seconds.
Q: Where should I pour the powdered laundry products when doing my laundry?
A: If you are using powdered laundry detergent, load it in the main detergent dispenser section of the
manual dispenser after removing the liquid detergent insert. Powdered laundry agents or powdered
color safe bleach should be put directly into the drum. These products can be put in the empty drum
before loading or on top of the laundry after loading the washer.
Error Messages
Problem
Door open The door is opened.
• Open and close the door again. If the message keeps appearing, unplug the power cord
Door unlocked The door is not secured.
• Check for objects around the door and door seal. If the message keeps appearing, unplug
Water supply Water supply faucets are not fully open.
• Make sure that the water faucets are fully open.
Water inlet hoses are kinked, pinched, or crushed.
• Make sure that the hoses are not kinked, pinched or crushed behind or under the washer.
Water inlet filters are clogged.
• Clean the inlet filters. See MAINTENANCE.
and call for service.
the power cord and call for service.
Be careful when moving the washer during cleaning or maintenance.
Possible Cause & Solution