Table of Contents
Advertisement
EMERGENCY DRAIN
If the appliance cannot drain the water, carry out
the same procedure, described in 'Cleaning the
drain pump' paragraph. If necessary, clean the
pump.
FROST PRECAUTIONS
If the appliance is installed in an area where the
temperature can reach values around 0° C or drop
below, remove the remaining water from the inlet
hose and the drain pump.
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
CONSUMPTION VALUES
INTRODUCTION
See the web link www.theenergylabel.eu for detailed informa-
tion about Energy Label.
The QR code on the energy label supplied with the appliance pro-
vides a web link to the product information sheet. Keep the energy
label for reference together with the user manual and all other
documents provided with this appliance.
LEGEND
kg
Laundry load.
kWh
Energy consumption.
Litres
Water consumption.
%
Remaining moisture at the end of spinning phase. The higher is the spin speed, the higher is
the noise and the lower is the remaining moisture.
Values and programme duration may differ depending on different conditions (e.g. room tem-
perature, water temperature and pressure, load size and type of laundry, supply voltage) and
also if you change the default setting of a programme.
28
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
4. Empty the drain pump. Refer to the emergency
drain procedure.
5. When the drain pump is empty, install the inlet
hose again.
WARNING! Make sure that the
temperature is higher than 0 °C before
you use the appliance again.
The manufacturer is not responsible
for damages caused by low
temperatures.
hh:m
Programme duration.
m
°C
Temperature in the laundry.
rpm
Spin speed.
Advertisement
Table of Contents
