Table of Contents
Advertisement
Erasing blank port ions aut om at ically
(Sm art Space/Aut o Cut )
The deck can be set to automatically erase any blanks that
are produced when the signal is interrupted during
recording. The function which activates (Smart Space or
Auto Cut) depends on the length of the interruption, as
described below.
Sm art Space
If the signal is interrupted for less than 30 seconds, Smart
Space replaces the blank portion with a blank space of
about three seconds, then continues the recording. "Smart
Space" appears in the display during this time.
Aut o Cut
If the signal is interrupted for about 30 seconds , Auto Cut
replaces the blank portion with a blank space of about
three seconds, then pauses the recording. "Auto Cut"
appears in the display during this time.
Do the procedure below to turn Smart Space and Auto
Cut on or off.
1
While the deck is stopped, press M ENU/ NO tw ice.
"Setup Menu" appears in the display.
2
Turn AM S (or press . / > repeatedly) until
"S.Space" appears, then press AM S or YES.
3
Turn AM S (or press . / > repeatedly) to select
the setting, then press AM S or YES.
To
Turn on Smart Space and Auto Cut
Turn off Smart Space and Auto Cut
4
Press M ENU/ NO.
Notes
• If you start recording with no signal input, Smart Space and
Auto Cut will not operate regardless of the setting.
• Smart Space does not affect the order of the track numbers
being recorded, even if the blank space occurs in the middle of
a track.
• Auto Cut is automatically turned on or off in tandem with
Smart Space.
• If you turn off the deck or disconnect the AC power cord, the
deck will store the last setting ("S.Space On" or "S.Space Off")
and apply it the next time you turn on the deck.
Downloaded from:
https://www.usersmanualguide.com/
M arking Track Num bers
While Recording
You can mark track numbers either manually or
automatically while recording. By marking track
numbers at specific points, you can quickly locate the
points later or edit the MD easily.
M arking t rack num bers m anually
(M anual Track M arking)
Press z at the point w here you w ant to add a track
number w hile recording.
M arking t rack num bers aut om at ically
(Aut om at ic Track M arking)
When recording from a CD player or MD deck connected
to the DIGITAL IN connector, the deck marks track
numbers in the same sequence as the source. When
recording from other sources connected to the DIGITAL
IN connector or a source connected to the LINE
Select
(ANALOG) IN jacks, do the procedure below to mark
S.Space On (factory
track numbers automatically.
setting)
1
S.Space Off
2
3
4
` / 1
While the deck is stopped, press M ENU/ NO tw ice.
"Setup Menu" appears in the display.
Turn AM S (or press . / > repeatedly) until
"T.M ark" appears, then press AM S or YES.
Turn AM S (or press . / > repeatedly) to select
the setting, then press AM S or YES.
To
Turn on Automatic Track Marking T.Mark LSync (factory
Turn off Automatic Track Marking T.Mark Off
Press M ENU/ NO.
The deck marks a track number whenever the input
signal level drops to –50 dB (the trigger level for
Automatic Track Marking) or below for at least 1.5
seconds.
(Track M arking)
z
Z
N
X
x
z
.
>
m
M
M ENU/ NO
AM S YES
Select
setting)
17
Advertisement
Table of Contents
