Use Of Commands - JVC HMD-VS1DW Instructions Manual

Use of Commands

It is possible to control this unit by connecting it to a PC using a USB cable.
Required environment
Windows10
Terminal software
Connect this equipment and PC with USB cable
1
For the first connection, the driver will be installed automatically. (For Windows10)
Make sure you have "USB Serial Device (COMx)" in "Ports (COM and LPT)" in Device Manager.
"x" changes depending on the environment.
0
Start the terminal software
2
Connect to "USB serial device (COMx)" with any terminal software.
Recommended settings
Speed
Data
Parity
Stop bit
Flow Control
Use commands
3
You can operate this unit and acquire the status by entering commands on the terminal.
ex.
state [arg1]
[arg1] l Gets the status of the left panel.
r Gets the status of the right panel.
*1 "state" can be abbreviated as "st"
*2 Please leave a "space" between "state" and "arg1"
Result
STATE_NONE
STATE_WAITCABLE
STATE_CONNECTING
STATE_NORMAL
36
115200
8 bit
none
1 bit
none
Meaning
The power switch is off.
The power switch is ON and the DisplayPort cable is not connected.
The DisplayPort cable is connected and waiting for the connection to
stabilize.
The connection with the DisplayPort cable is stable.