External Input Setting - Fujitsu AIRSTAGE UTY-DCGYZ2 Operation Manual

3-4-6-2. Network Setting
When "Wired LAN" is selected at LAN setting, set the network.


4 5
3-4-6-3. Indoor Unit Sensor Room Temp. Display Setting
Display the room temp. to the operating indoor unit even if remote controller or option sensor is not used.
(4)
(1)
3-4-7. External Input Setting
Perform the external input setting.
(3)
(1)

En-40
3
(3)
(2)
(2)

(1) Set the item and tap the [OK] button.
[Initial value: Addresses are set as shown in the left figure.]
No. Item
"IP Address" (*) Sets "IP address" of this controller.

"Subnet Mask"
Sets "Subnet mask" of this controller.

(*)
"Default Sets "Default Gateway" of this
3
Gateway" (*) controller.
"Primary DNS" Inputs "Primary DNS" (Domain Network
4
(*) Service) of this controller.
"Secondary Inputs "Secondary DNS" (Domain
5
DNS" (*) Network Service) of this controller.
(*) [***.***.***.***] (Input 0 to 255 at "***".)
(1) Tap the MENU button.
(2) Tap the [Installer Setting].
(3) Tap the [Indoor unit sensor room temp. display].
(4) Tap the [Enable] or [Disable].
(1) Tap the MENU button.
(2) Tap the [Installer Setting].
(3) Tap the [External Input Setting].
(4) Set the item and tap the [OK] button.
No. Item
Selects "Operation" for external input.
"Operation" "Emergency Stop", "All On/Off", "Not

Used"
Selects "Input method".
"Input Method"

"Edge", "Pulse"
Description
Description