Black & Decker BL950 Instruction Manual

S S t t r r a a i i g g h h t t T T u u b b
S S t t r r a a i i g g h h t t T T u u b b
INSTRUCTION MANUAL
Date Code
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON PLEASE CALL
1-800-54-HOW-TO (544-6986)
IF YOU SHOULD EXPERIENCE A PROBLEM
WITH YOUR BLACK & DECKER PRODUCT,
CALL 1-800-54-HOW-TO (544-6986)
BEFORE YOU CALL, HAVE THE FOLLOWING INFORMATION AVAILABLE, CATALOG No.,
TYPE No., AND DATE CODE. IN MOST CASES, A BLACK & DECKER REPRESENTATIVE
CAN RESOLVE YOUR PROBLEM OVER THE PHONE. IF YOU HAVE A SUGGESTION OR
COMMENT, GIVE US A CALL. YOUR FEEDBACK IS VITAL TO BLACK & DECKER.
KEY INFORMATION YOU SHOULD KNOW:
• Before operating, make sure that the blower tube assembly is locked in place.
• The power switch must be OFF before attaching blower tube assemby.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
Form No. 244620-01 Cat. # BL950 (AUG. '03)
WARNING: IMPORTANT SAFETY WARNINGS AND INSTRUCTIONS
TO REDUCE RISK OF INJURY:
• Before any use, be sure everyone using this tool reads and understands all safety instructions and other information
contained in this manual.
• Save these instructions and review frequently prior to use and in instructing others.
• Do not point tool discharge at self or bystanders.
• Keep long hair and loose clothing away from openings and moving parts.
WARNING:
When using an electric appliance, basic safety precautions should always be followed to reduce risk
of fire, electric shock, and personal injury, including the following
WARNING:
Some dust created by this product contains chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm. Some examples of these chemicals are:
• compounds in fertilizers
• compounds in insecticides, herbicides and pesticides
• arsenic and chromium from chemically treated lumber
To reduce your exposure to these chemicals, wear approved safety equipment such as dust masks
that are specially designed to filter out microscopic particles.
WARNING:
This product contains chemicals, including lead, known to the State of California to cause cancer, and
birth defects or other reproductive harm. Wash hands after handling.
CAUTION: Wear appropriate personal hearing protection during use. Under some conditions and duration of use, noise from
this product may contribute to hearing loss.
READ ALL INSTRUCTIONS BEFORE USING BLOWER.
GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL TOOLS
• READ and follow all instructions.
• DO NOT place outlet of blower near eyes or ears when operating.
• THIS APPLIANCE IS PROVIDED WITH DOUBLE INSULATION. Use only identical replacement parts. See instructions for
servicing of double insulated appliances.
• STORE IDLE TOOLS. When not in use, the unit should be stored in a dry, high or locked-up place - out of reach of children.
• DON'T OVERREACH. Keep proper footing and balance at all times.
• MAINTAIN TOOL WITH CARE. Keep tool clean for best and safest performance. Follow instructions for proper maintenance.
• DO NOT attempt to repair the blower. To assure product safety and reliability, repairs, maintenance, and adjustments should be
performed by Black & Decker service centers or authorized service centers, always using Black & Decker replacement parts.
• DO NOT operate blower in a gaseous or explosive atmosphere. Motors in these tools normally spark, and the sparks might
ignite fumes.
• USE EXTRA CARE when cleaning on stairs.
• DO NOT leave appliance when plugged in. Unplug from outlet when not in use and before servicing.
• DO NOT allow to be used as a toy. Close attention is necessary when used by or near children. Not recommended for use
by children.
• DO NOT attempt to clear clogs from tool without first unplugging it.
• USE ONLY as described in this manual. Use only manufacturer's recommended attachments.
• DO NOT use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left
outdoors, or dropped into water, return it to a service center.
• DO NOT pull or carry by cord, use cord as a handle, or pull cord around sharp edges or corners. Keep cord away from
heated surfaces.
• DO NOT unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• DO NOT put any objects into openings. Do not use with any opening blocked; keep free of dust, lint, hair and everything
that may reduce air flow.
• KEEP hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
• TURN OFF all controls before unplugging.
• DO NOT immerse any part of the tool in liquid.
• DO NOT handle plug or appliance with wet hands.
• KEEP CHILDREN, BYSTANDERS AND ANIMALS AWAY from the work area a minimum of 30 feet (10 meters) when starting
or operating the tool.
• INSPECT THE AREA before using the tool. Remove all debris and hard objects such as rocks, glass, wire, etc. that can
ricochet, be thrown, or otherwise cause injury or damage during operation.
WARNING:
To reduce the risk of electrical shock; do not expose to rain, do not use on wet surfaces. Store indoors.
SAVE THESE INSTRUCTIONS.
1A
Off
Arrêt
Apagado
e e B B l l o o w w e e r r / / S S w w e e e e
e e B B l l o o w w e e r r / / S S w w e e e e
Catalog Number BL950
Copyright © 2003 Black & Decker
.
On
1B
En marche
Encendido
2
p p e e r r
p p e e r r
3
Your Blower is double insulated to give you added safety. In a double insulated appliance, two systems of insulation are
provided instead of grounding. No grounding means is provided on a double insulated appliance, nor should a means for
grounding be added to the appliance. Servicing a double insulated appliance requires extreme care and knowledge of the
system and should be done only by qualified service personnel. Replacement parts for a double insulated appliance must
be identical to the parts they replace. A double insulated appliance is marked with the words double insulated or "double
insulation". The symbol (square within a square) may also be marked on the appliance.
Double insulated tools have 2-wire cords and can be used with 2-wire or 3-wire extension cords. Only round jacketed
extension cords should be used, and we recommend that they be listed by Underwriters Laboratories (U.L.) (C.S.A. in
Canada). If the extension will be used outside, the cord must be suitable for outdoor use. Any cord marked as outdoor can
also be used for indoor work.
An extension cord must have adequate wire size (AWG or American Wire Gage) for safety, and to prevent loss of power
and overheating. The smaller the gage number of the wire, the greater the capacity of the cable, that is 16 gage has more
capacity than 18 gage. When using more than one extension to make up the total length, be sure each individual extension
contains at least the minimum wire size.
To determine the minimum wire size required, refer to the chart below. Before using an extension cord, inspect it for loose
or exposed wires, damaged insulation, and defective fittings. Make any needed repairs or replace the cord if necessary.
Printed in Mexico
To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This equipment
must be used with a suitable polarized 2 wire or 3 wire extension cord. Polarized connections will fit together only one
way. Make sure that the receptacle end of the extension cord has large and small blade slot widths. If the plug does not fit
fully into the extension cord, reverse the plug. If it still does not fit, obtain a suitable extension cord. If the extension cord
does not fit fully into the outlet, contact a qualified electrician to install the proper outlet. Do not change the tool plug or
extension cord in any way.
NOTE: Ensure the blower is switched off before attaching extension cord.
• SECURING POWER SUPPLY CORD
Secure the extension cord in the built-in cord retainer as shown in Figure 1A. Fold the extension cord into a loop
approximately 12 inches (30 cm) from the receptacle end of the extension cord. Push the folded loop of the extension cord
up through the loop opening at the rear of the blower (see Figure 1A). Place the loop of the extension cord around the
hook at the rear of the blower and gently pull on the extension cord until it is snug around the hook. Now plug the end of
the extension cord into the plug blades at the end of the tool cord (see instructions above for use of polarized plug). Ensure
that the cord end is fully seated onto the plug blades.
The switch can be operated by moving the lever from side to side. The "ON" and "OFF" positions are marked on the
housing as shown in Figure 1B.
CAUTION:
CAUTION:
NOTE: Ensure the blower is switched off and is disconnected from the power supply before attaching or removing the
blower tubes, or attaching or adjusting the shoulder strap. Ensure the blower is switched off before putting the strap
onto or off of your shoulder.
• TUBE ASSEMBLY
Assemble the two straight tubes (see Figure 2) by sliding the two together until the lock button engages (see Figure 3). To
separate the two tubes push the lock button and pull the tubes apart. To attach the straight tubes to the blower, line up the
tubes with the blower housing as shown in Figure 4. Push the tubes into the blower housing and twist clockwise to lock. To
remove, twist counter-clockwise and pull.
• OPERATION WITH TUBES (FIGURE 5)
Hold the blower with one hand as shown in Figure 5 and sweep from side to side with the nozzle several inches above the
ground. Slowly advance keeping the accumulated pile of debris in front of you.
• CLEANING AND STORAGE
TURN OFF AND UNPLUG TOOL! (Unplug extension cord at power source.)
CAUTION:
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of
the tool into a liquid.
Your blower should be stored in a dry place. Do not store the tool on or adjacent to fertilizers or chemicals. Such storage
can cause rapid corrosion of the metal parts.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized
service centers or other qualified service organizations, always using identical replacement parts.
Service Information
Black & Decker offers a full network of company-owned and authorized service locations throughout North America. All
Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power
tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker
location nearest you.
To find your local service location, refer to the yellow page directory under "Tools—Electric" or call: 1-800-54-HOW-TO.
Full Two-Year Home Use Warranty
Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material or workmanship. The defective
product will be replaced or repaired at no charge in either of two ways:
The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased (provided
that the store is a participating retailer). Returns should be made within the time period of the retailer's policy for exchanges
(usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with the retailer for their specific
return policy regarding returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or authorized Service Center for
repair or replacement at our option. Proof of purchase may be required. Black & Decker owned and authorized service
centers are listed under "Tools-Electric" in the yellow pages of the phone directory.
This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other rights
which vary from state to state. Should you have any questions, contact the manager of your nearest Black & Decker Service
Center.
This product is not intended for commercial use.
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
4
Lock button
Bouton de verrouillage
Boton de seguridad
5
SERVICING OF DOUBLE INSULATED APPLIANCES
SAFETY RULES AND INSTRUCTIONS: EXTENSION CORDS
Minimum Gage for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25 26-50
240V 0-50 51-100
Ampere Rating
More Not more American Wire Gage
Than Than
0 - 6 18 16
6 - 10 18 16
10- 12 16 16
12- 16 14 12
SAFETY RULES AND INSTRUCTIONS: POLARIZED PLUG
BEFORE OPERATING
SWITCH
DO NOT POINT TOOL DISCHARGE AT SELF OR BYSTANDERS.
OPERATION
Always wear safety glasses. Wear a filter mask if the operation is dusty. Use of gloves, long pants
and substantial footwear is recommended. Keep long hair and loose clothing away from openings
and moving parts.
THIS BLOWER IS NOT RECOMMENDED FOR COMMERCIAL USE.
MAINTENANCE
DO NOT POUR OR SPRAY WATER ON THE TOOL.
IMPORTANT
51-100 101-150
101-200 201-300
16 14
14 12
14 12
Not Recommended
See 'Tools-Electric'
– Yellow Pages –
for Service & Sales