Activate Registration Mode On Base; Register Repeater To Base - NEC Dterm DTL-RPT-2 Manual

term
D Cordless DECT
___________________________________________________________________________________
3.
4.
5.
S 6 A
ECTION CTIVATE
You need to activate registration mode on your base before you can register your
repeater to it. Refer to the Owner's Manual for your base unit for registration
instructions.

6.1
___________________________________________________________________________________
DTL-RPT-2 Cordless DECT Repeater Guide
Insert the AC adapter connector into the yellow adapter opening. Thread the
cord according to the illustration.
Figure 2-7 Threading the AC Adapter Cord
Carefully replace the cover, and press until you hear it click. Do not angle it as
you replace it.
Use the AC adapter to connect the repeater to a standard 120 V AC outlet. (Do
not use an outlet controlled by a wall switch!) The LED on the repeater flashes
briefly, then remains on and steady.
R
EGISTRATION
You only have to activate registration on the base once, regardless of how many repeaters
you want to register (up to 6).

Register Repeater to Base

You can register up to six repeaters to each base. Repeat these steps as
needed for each repeater. The repeater seeks out the base with strongest
DECT/GAP signal and automatically registers to that base. Make sure no
other bases in range are in registration mode. If more than one base is in
registration mode at the same time, you cannot control which base the
repeaters register to.
M B
ODE ON ASE
Issue 1.0
2 - 7