Removing The Rear Brake Caliper; Disassembling The Rear Brake Caliper (For Yp125Ra) - Yamaha MBK XMAX 2014 Service Manual

b. Loosen the bleed screw and push the brake
caliper pistons into the brake caliper with your
finger.
c. Tighten the bleed screw.
Bleed screw
6 Nm (0.6 m·kgf, 4.3 ft·lbf)
d. Install new brake pad shims onto each new
brake pad.
e. Install new brake pad supports and new
brake pads.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
3. Install:
• Rear brake caliper
• Rear brake caliper retaining bolts
Rear brake caliper retaining bolt
27 Nm (2.7 m·kgf, 20 ft·lbf)
4. Check:
• Brake fluid level
Below the minimum level mark "a" → Add the
specified brake fluid to the proper level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-10.
a
5. Check:
• Brake lever operation
Soft or spongy feeling → Bleed the brake sys-
tem.
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM (ABS) (for YP125RA)" on
page 3-11.
2
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS2DM1009

REMOVING THE REAR BRAKE CALIPER

TIP
Before removing the brake caliper, drain the
brake fluid from the entire brake system.
1. Remove:
• Brake hose union bolt "1"
• Copper washers "2"
1
• Rear brake hose "3"
TIP
Put the end of the brake hose into a container
and pump out the brake fluid carefully.
A
▲▲▲
B
A. For YP125R
B. For YP125RA
EAS2DM1011
DISASSEMBLING THE REAR BRAKE
CALIPER (for YP125RA)
1. Remove:
• Brake caliper pistons "1"
• Brake caliper piston dust seals "2"
• Brake caliper piston seals "3"
1
3
4-55
REAR BRAKE
1
2
3
2
2
3
1
3
1
2